User manual GIGABYTE GA-7IXE

[. . . ] FCC Compliance Statement: This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular Eric Lu installation. [. . . ] ( Default value ) Set SDRAM CAS Latency to 3 Cycles. Set SDRAM CAS Latency to 4 Cycles. · SDRAM TRCD Timing This function specify the delay from the activation of a bank to the time that a read or write command is accepted. 1 Cycle 2 Cycle 3 Cycle 4 Cycle Set SDRAM TRCD Timing Value to 1 Cycle. (Default value) Set SDRAM TRCD Timing Value to 3 Cycle. Set SDRAM TRCD Timing Value to 4 Cycle. · DRAM Integrity Mode Disabled ECC Disabled this function. (Default Value) Set DRAM Integrity Mode to ECC. · Memory Hole Disabled 14MB-15MB 15MB-16MB 14MB-16MB Normal Setting. (Default Value) Set Address=14~15MB remap to ISA BUS. Set Address=14~16MB remap to ISA BUS. · DRAM Burst Refresh Disabled Enabled Disabled this function. (Default Value) 36 7IXE Motherboard · Graphics Aperture Size 32 MB 64 MB 128 MB 256 MB 512 MB 1 GB 2 GB Display Graphics Aperture Size is 32MB. (Default Value) Display Graphics Aperture Size is 128MB. Display Graphics Aperture Size is 256MB. Display Graphics Aperture Size is 512MB. Display Graphics Aperture Size is 2GB. · USB Function Disabled Enabled Disabled USB Function. (Default Value) · USB KB Legacy Support Disabled Keyboard Keyb+Mouse Disable USB KB Legacy Support. (Default Value) Set USB KB Legacy Support to Keyboard. Set USB KB Legacy Support to Keyb+Mouse. 37 BIOS Setup Power Management Setup AMIBIOS SETUP ­ POWER MANAGEMENT SETUP ( C ) 1998 American Megatrends, Inc. All Rights Reserved Power Management/APM Video Power Down Mode Hard Disk Power Down Mode Standby Time Out (Minute) Suspend Time Out (Minute) Display Activity IRQ3 IRQ4 IRQ5 IRQ7 IRQ9 IRQ10 IRQ11 IRQ13 IRQ14 IRQ15 Thermal Slow Clock Ratio Soft-off by Power Button System after AC Back Modem Ring On/Wake On Lan Enabled Suspend Suspend Disabled Disabled Ignore Both Both Ignore Both Both Both Both Both Both Both 50. 0% Instant Off PME Event Wake Up Resume by Alarm Data (of Month) Alarm Hour Alarm Minute Alarm Second Alarm Keyboard PowerOn Function Password for PowerOn Mouse PowerOn function Disabled Disabled 15 12 30 30 Disabled N/A Disabled Memory Enabled ESC: Quit : Select Item F1 : Help PU/PD+/-/ : Modify F5 :Old Values(Shift)F2:Color F6 : Load BIOS Defaults F7 : Load Setup Defaults Figure 6: Power Management Setup · Power Management / APM Enabled Disabled Enabled Green & software APM function. (Default Value) Disabled Green & software APM function. · Video Power Down Mode Disabled Suspend Stand By Disabled Video Power Down Mode Function. (Default Value) Set Video Power Down Mode to Stand By. · Hard Disk Power Down Mode Disabled Suspend Stand By Disabled Hard Disk Power Down Mode Function. Set Hard Disk Power Down Mode to Suspend. (Default Value) Set Hard Disk Power Down Mode to Stand By. 38 7IXE Motherboard · Standby Time Out (Minute) Disabled 1 2 4 8 10 20 30 40 50 60 Disabled Standby Time Out Function. (Default Value) Enabled Standby Time Out after 1min. [. . . ] If the hard disk cylinder number is over 1024, then the user can select LBA mode or LARGER mode for DOS partition larger than 528 MB. 54 7IXE Motherboard Save & Exit Setup AMIBIOS SIMPLE SETUP UTILITY-VERSION 1. 20 ( C ) 1998 American Megatrends, Inc. All Rights Reserved STANDARD CMOS SETUP BIOS FEATURES SETUP CHIPSET FEATURES SETUP POWER MANAGEMENT SETUP PNP/PCI CONFIGURATION LOAD BIOS DEFAULTS LOAD SETUP DEFAULTS INTEGRATED PERIPHERALS PC HEALTH STATUS SUPERVISOR PASSWORD USER PASSWORD IDE HDD AUTO DETECTION SAVE to CMOS and EXIT(Y/N)?Y EXIT WITHOUT SAVING SAVE & EXIT SETUP ESC : Quit : Select Item (Shift) F2 : Change Color F5 : Old Values F6 : Load BIOS Defaults F7: Load Setup Defaults F10: Save 7 Exit Save Data to CMOS & Exit SETUP Figure 13: Save & Exit Setup Type "Y" will quit the Setup Utility and save the user setup value to RTC CMOS. Type "N" will return to Setup Utility. 55 BIOS Setup Exit Without Saving AMIBIOS SIMPLE SETUP UTILITY-VERSION 1. 20 ( C ) 1998 American Megatrends, Inc. [. . . ]