User manual GIGABYTE GA-8IPE775 PRO

[. . . ] When you installing AGP card, please make sure the following notice is fully understood and practiced. If your AGP card has "AGP 4X/8X (1. 5V) notch"(show below), please make sure your AGP card is AGP 4X/8X (1. 5V). AGP 4X/8X notch Caution: AGP 2X card is not supported by Intel® 845(GE/PE) / 845(E/ G) / 850(E) / E7205 / 865(G/PE/P) / 875P. You might experience system unable to boot up normally. Example 1: Diamond Vipper V770 golden finger is compatible with 2X/4X mode AGP slot. [. . . ] automatically. Current CPU/POWER /SYSTEM FAN Speed (RPM) Detect CPU/POWER/SYSTEM Fan speed status automatically. Only for GA-8IPE775 Pro. Only for GA-8IPE775-G. GA-8IPE775 Series Motherboard - 46 - CPU Warning Temperature 60 oC / 140 o F 70 oC / 158 o F 80 C / 176 F 90 oC / 194 o F Disabled o o English Monitor CPU Temp. (Default value) CPU FAN Fail Warning Disabled Enabled Fan Warning Function Disable. (Default value) Fan Warning Function Enable. POWER FAN Fail Warning Disabled Enabled Fan Warning Function Disable. (Default value) Fan Warning Function Enable. SYSTEM FAN Fail Warning Disabled Enabled Fan Warning Function Disable. (Default value) Fan Warning Function Enable. CPU Smart FAN Control Disabled Enabled Disable this function. Enable CPU Smart Fan control function. (Default value) a. When the CPU temperature is higher than 70 degrees Celsius, CPU fan will run at full speed. When the CPU temperature is between 50 and 70 degrees Celsius, CPU fan will run at high speed. When the CPU temperature is between 40 and 50 degrees Celsius, CPU fan will run at medium speed. When the CPU temperature is lower than 40 degrees Celsius, CPU fan will run at low speed. Only for GA-8IPE775 Pro. Only for GA-8IPE775-G. - 47 BIOS Setup English Frequency/Voltage Control CMOS Setup Utility-Copyright (C) 1984-2004 Award Software Frequency/Voltage Control CPU Clock Ratio CPU Host Clock Control x CPU Host Frequency (Mhz) x AGP/PCI/SRC Fixed Memory Frequency For Memory Frequency (Mhz) AGP/PCI/SRC Frequency (Mhz) DIMM OverVoltage Control AGP OverVoltage Control CPU Voltage Control Normal CPU Vcore [15X] [Disabled] 100 66/33/100 [Auto] 266 66/33/100 [Normal] [Normal] [Normal] 1. 3875V Item Help Menu Level : Move Enter: Select F5: Previous Values +/-/PU/PD: Value F6: Fail-Save Default F10: Save ESC: Exit F7: Optimized Defaults F1: General Help Incorrect using these features may cause your system broken. For power End-User use only! CPU Clock Ratio This option will not be shown or not be available if you are using a CPU with the locked ratio. This setup option will automatically assign by CPU detection. The option will display "Locked" and read only if the CPU ratio is not changeable. CPU Host Clock Control Please note that if your system is overclocked and cannot restart, please wait 20secs. for automatic system restart or clear the CMOS setup data and perform a safe restart. Disabled Enabled Disable CPU Host Clock Control. (Default value) Enable CPU Host Clock Control. CPU Host Frequency (Mhz) This item will be available when "CPU Host Clock Control" is set to Enabled. 100MHz ~ 355MHz Set CPU Host Clock from 100MHz to 355MHz. If you use FSB400 Pentium 4 processor, please set "CPU Clock" to 100MHz. If you use FSB533 Pentium 4 processor, please set "CPU Clock" to 133MHz. If you use FSB800 Pentium 4 processor, please set "CPU Clock" to 200MHz. Incorrect using it may cause your system broken. [. . . ] Support : http://tw. giga-byte. com/TechSupport/ServiceCenter. htm Non-Tech. Support(Sales/Marketing) : http://ggts. gigabyte. com. tw/nontech. asp WEB address : http://www. gigabyte. de Japan NIPPON GIGA-BYTE CORPORATION WEB address : http://www. gigabyte. co. jp Singapore GIGA-BYTE SINGAPORE PTE. Support : http://tw. giga-byte. com/TechSupport/ServiceCenter. htm Non-Tech. Support(Sales/Marketing) : http://ggts. gigabyte. com. tw/nontech. asp WEB address: http://www. gigabyte. com. sg U. K. [. . . ]