User manual GIGABYTE GA-E240N

[. . . ] Changes to the specifications and features in this manual may be made by GIGABYTE without prior notice. No part of this manual may be reproduced, copied, translated, transmitted, or published in any form or by any means without GIGABYTE's prior written permission. Documentation Classifications In order to assist in the use of this product, GIGABYTE provides the following types of documentations: For quick set-up of the product, read the Quick Installation Guide included with the product. For detailed product information, carefully read the User's Manual. For product-related information, check on our website at: http://www. gigabyte. com Identifying Your Motherboard Revision The revision number on your motherboard looks like this: "REV: X. X. " For example, "REV: 1. 0" means the revision of the motherboard is 1. 0. Check your motherboard revision before updating motherboard BIOS, drivers, or when looking for technical information. [. . . ] Specifiesthebootorderfromtheavailabledevices. Usetheupordownarrowkeytoselectadevice and press <Enter> to accept. Options are: Floppy, LS120, Hard Disk, CDROM, ZIP, USB-FDD, USB-ZIP, USB-CDROM, USB-HDD, Legacy LAN, Disabled. Specifieswhetherapasswordisrequiredeverytimethesystem boots, oronlywhenyouenterBIOS Setup. Afterconfiguringthisitem, setthepassword(s)undertheSet Supervisor/User Password item in the BIOS Main Menu. Setup A password is only required for entering the BIOS Setup program. (Default) System A password is required for booting the system and for entering the BIOS Setup program. (Self Monitoring and Reporting Technology) capability of your hard drive. This feature allows your system to report read/write errors of the hard drive and to issue warnings when a third party hardware monitor utility is installed. (Default: Enabled) - 37 BIOS Setup Password Check HDD S. M. A. R. T. Capability Away Mode Enables or disables Away Mode in Windows XP Media Center operating system. Away Mode allows the system to silently perform unattended tasks while in a low-power mode that appears off. (Default: Disabled) AllowsthesystemtocopytheBIOSimagefiletotheharddrive. IfthesystemBIOSiscorrupted, itwill berecoveredfromthisimagefile. (Default:Disabled) Specifies the first initiation of the monitor display from the PCI Express graphics card or the onboard graphics. Ifacableproblemoccursonaspecifiedpairofwires, theStatusfieldwillshowShort and then length shown will be the approximate distance to the fault or short. Example: Part1-2 Status = Short / Length = 2m Explanation: A fault or short might occur at about 2m on Part 1-2. Note: Part 4-5 and Part 7-8 are not used in a 10/100 Mbps environment, so their Statusfieldswillshow Open, and the length shown is the approximate length of the attached LAN cable. BIOS Setup - 40 - Onboard Audio Function Enables or disables the onboard audio function. (Default: Enabled) If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to Disabled. Enables or disables the Renesas D720200 USB controller. (Default: Enabled) Onboard USB 3. 0 Controller (Renesas D720200 USB Controller) USB Controllers USB Legacy Function Enables or disables the integrated USB controllers. (Default: Enabled) Disabled will turn off all of the USB functionalities below. Allows USB keyboard to be used in MS-DOS. (Default: Enabled) USB Storage Function Determines whether to detect USB storage devices, including USB flash drives and USB hard drives during the POST. (Default: Enabled) - 41 - BIOS Setup 2-7 Power Management Setup CMOS Setup Utility-Copyright (C) 1984-2010 Award Software Power Management Setup [S3(STR)] [Instant-off] [Enabled] [Disabled] [Enabled] [Enabled] [Disabled] [Disabled] Enter [Soft-Off] [Disabled] Everyday 0:0:0 [Disabled] Item Help Menu Level ACPISuspendType Soft-OffbyPowerbutton USBWakeUpfromS3 ModemRingResume PMEEventWakeUp HPET Support (Note) PowerOnByMouse PowerOnByKeyboard x KBPowerONPassword ACBackFunction Power-OnbyAlarm x Date (of Month) x Resume Time (hh:mm:ss) ErPSupport Enter: Select higf: Move F5: Previous Values +/-/PU/PD: Value F6: Fail-Safe Defaults F10: Save ESC: Exit F1: General Help F7: Optimized Defaults ACPI Suspend Type SpecifiestheACPIsleepstatewhenthesystementerssuspend. S3(STR) Enables the system to enter the ACPI S3 (Suspend to RAM) sleep state. [. . . ] Is the power connector of the CPU cooler connected to the CPU_FAN header properly?Yes Yes Isolate the short circuit. Theproblemisverifiedandsolved. Connect the CPU cooler power cable to the motherboard. Theproblemisverifiedandsolved. No Correctly insert the memory into the memory socket. Check if the memory is installed properly on the memory slot. [. . . ]