User manual GIGABYTE GA-F2A85XM-HD3

[. . . ] GA-F2A85XM-HD3 User's Manual Rev. 1001 12ME-F285HD3-1001R Motherboard GA-F2A85XM-HD3 Motherboard GA-F2A85XM-HD3 Nov. 2, 2012 Copyright ©©2012 GIGA-BYTE TECHNOLOGY CO. , LTD. The trademarks mentioned in this manual are legally registered to their respective owners. Disclaimer Information in this manual is protected by copyright laws and is the property of GIGABYTE. [. . . ] When enabled, the CPU core frequency will be reduced during system halt state to decrease power consumption. The C6 state is a more enhanced power-saving state than C1. (Default: Enabled) (Note) This item is present only when you install a CPU that supports this feature. - 30 - && CPU core Control Allows you to determine whether to manually enable/disable CPU cores. Automatic mode allows the BIOS to enable all CPU cores (number of cores available depends on the CPU being used). (Default: Automatic mode) && Extreme Memory Profile (X. M. P. ) (Note) Allows the BIOS to read the SPD data on XMP memory module(s) to enhance memory performance when enabled. (Default) Profile1  Uses Profile 1 settings. Profile2 (Note)  Uses Profile 2 settings. Allows the BIOS to read the SPD data on AMP memory module(s) to enhance memory performance when enabled. (Default: Disabled) Allows you to set the system memory multiplier. Auto sets memory multiplier according to memory SPD data. (Default: Auto) This value is automatically adjusted according to the BCLK/PCIe Clock Control and System Memory Multiplier settings. && AMD Memory Profile (A. M. P. ) (Note) && System Memory Multiplier && Memory Frequency (MHz) `` Advanced Memory Settings && Extreme Memory Profile (X. M. P. ) (Note), System Memory Multiplier, Memory Frequency(Mhz) The settings above are synchronous to those under the same items on the Advanced Frequency Settings menu. (Note) This item is present only when you install a memory module that supports this feature. - 31 - && DRAM Timing Selectable Quick and Expert allows the memory timing settings below to be configurable. Options are: Auto (default), Quick, Expert. When using a non-XMP memory module or Extreme Memory Profile (X. M. P. ) is set to Disabled, this item will display as 1. 50V. When Extreme Memory Profile (X. M. P. ) is set to Profile1 or Profile2, this item will display the value based on the SPD data on the XMP memory. The value displayed here is dependent on the CPU being used. && Profile DDR Voltage && Profile VTT Voltage && Rank Interleaving Enables or disables memory rank interleaving. Enabled allows the system to simultaneously access different ranks of the memory to increase memory performance and stability. (Default: Enabled) Enables or disables memory channel interleaving. Enabled allows the system to simultaneously access different channels of the memory to increase memory performance and stability. (Default: Enabled) && Channel Interleaving `` Channel A/B Timing Settings This sub-menu provides memory timing settings for each channel of memory. The respective timing setting screens are configurable only when DRAM Timing Selectable is set to Quick or Expert. [. . . ] Follow the on-screen instructions to install the driver that suits your operating system. When completed, proceed with the Windows XP installation. (The following instructions use Windows 7 as the example operating system. ) Boot from the Windows 7 setup disk and perform standard OS installation steps. When the screen requesting you to load the driver appears, select Browse. Then browse to the USB flash drive that contains the driver and select the location of the driver. [. . . ]