User manual GIGABYTE GS-R113L-RH

[. . . ] GS-R113-RH Series GS-R113V-RH GS-R113L-RH (OEM Model) 1U Rack Mount Server System Installation Guide AMD® AM2 Processor Motherboard Rev. 1. 1 GS-R113-RH Series Rack Mount Server Table of Content Safety, Care and Regulatory Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Drive A & B are 3 mode Floppy Drives. Halt On This function allows system to halt when an error is detected during Power-On-Self -Test. NO Errors All Errors The system boot will not stop for any error that may be detected and you will be prompted. Whenever the BIOS detects a non-fatal error the system boot will be stopped. All, But Keyboard The system boot will not stop for all errors except a keyboard error. (Default setting) All, But Diskette The system boot will not stop for all errors except a disk error. All, But Disk/Key The system boot will not stop for all errors except keyboard and disk errors. 33 GS-R113-RH Series Rack Mount Server Base Memory The POST of the BIOS will determine the amount of base (or conventional) memory installed in the system. ExtendedMemory The BIOS determines how much extended memory is present during the POST. This is the amount of memory located above 1 MB in the C PU's memory address map. Total Memory The POST of the BIOS will determine the amount of total memory installed in the system. 34 BIOS Setup Advanced Phoenix-Award WorkstationBIOS CMOS Setup Utility Main Advanced Security Boot PC Health Item Help Exit Advanced BIOS Feature Advanced Chipset Integrated Peripherals Power Management Setup PnP/PCI Configuration : Move Enter: Select +/-/PU/PD: Value F10: Save F5: Previous Values ESC: Exit F1: General Help F7: Optimized Defaults Figure 2: Advanced 35 GS-R113-RH Series Rack Mount Server Advanced BIOS Feature Phoenix-Award WorkstationBIOS CMOS Setup Utility Advanced Advanced BIOS Feature Quick Power On Self Test Boot Up Floppy Seek Boot Up Num-Lock Status x APIC Mode Full Screen LOGO Show Summary Screen Show DMI Event Log Clear All Event Log View DMI Event Log Mark DMI events Log as Read x x Event Log Capacity Event Log Vaildity : Move [Enabled] [Disabled] [On] Enabled [Disabled] [Enabled] [Enabled] [No] [Enter] [Enter] Space Available Vaild ESC: Exit F1: General Help Item Help Enter: Select +/-/PU/PD: Value F10: Save F5: Previous Values F7: Optimized Defaults Figure 2-1: Advanced BIOS Features Quick Power On Self Test This category speeds up Power On Self Test (POST) after you power on the computer. If it is set to Enable, BIOS will shorten or skip some check items during POST. Enabled Disabled Enables quick POST. (Default setting) Normal POST. 36 BIOS Setup Boot Up Floppy Seek During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360K type is 40 tracks 720K, 1. 2M and 1. 44M are all 80 tracks. Enabled BIOS searches for floppy disk drive to determine it is 40 or 80 tracks. Note that BIOS can not tell from 720K, 1. 2M or 1. 44M drive type as they are all 80 tracks. (Default value) Disabled BIOS will not search for the type of floppy disk drive by track number. Note that there will not be any warning message if the drive installed is 360K. Boot Up Num-Lock Status This option allows user to select power-on status for NumLock. Auto Enabled Disabled System auto assign. Disable this function. Full Screen Logo Show Enabled Disabled Show Full Logo when system boot. (Default setting) Summary Screen Show Enabled Disabled Show Summary screen when system boot. (Default setting) Disable this function. DMI Event Log Enabled Disabled Store POST error message to the DMI Event Log. (Default setting) Disable this function. Clear all DMI Event Log Yes No System will clear DMI event logs at next POST stage, and set this item to [No] automatically. Do not clear DMI event logs at next POST stage. (Default setting) 37 GS-R113-RH Series Rack Mount Server View DMI Event Log Press [Enter] to view all DMI event logs. Mark DMI Events Log as Read This option allows user to clear all DMI Event Logs immediately. Press [Enter] will pop up a confirmation window. Hit [Y] and [Enter] to clear all DMI event logs immediately. Event Log Capacity This item displays the information of Event Log Capacity. Events Log Vaildity This item displays the information of Event Log Vaildity. 38 BIOS Setup Advanced Chipset Phoenix-Award WorkstationBIOS CMOS Setup Utility Advanced Advanced Chipset OnChip VGA Frame Buffer Size PMU DRAM Configuration DRAM ECC enable x DRAM MCE enable System BIOS Cacheable : Move [Enabled] [64M] [Auto] [Press Enter] [Disabled] [Disabled] [Disabled] ESC: Exit F1: General Help Item Help Enter: Select +/-/PU/PD: Value F10: Save F5: Previous Values F7: Optimized Defaults Figure 2-2: Advanced Chipset OnChip VGA Enabled Disabled Enable Onboard VGA chipset. [. . . ] Click "Next" to start the installation 3. Select `Yes, I want to restart my computer now' and click "Finish". 65 GS-R113-RH Series Rack Mount Server C. Marvell LAN Driver Installation Insert the driver CD-title that came with your motherboard into your CD-ROM driver, the driver CD-title will auto start and show the installation guide. If not, please double click the CD-ROM device icon in "My computer", and execute the setup. exe. The CD auto run program starts, Click on "Marvell LAN Driver" to start the installation. [. . . ]