User manual GIGABYTE GT-P6000

[. . . ] If the screen does not appear, you can run "D: \TVCard. ) Then follow the on-screen instructions to install the driver and software with ease. (Note 1) The accessories may vary depending on different models. (Note 2) Please place the receiver at a location where remote control signals are available. [. . . ] (Note 2) Please place the receiver at a location where remote control signals are available. (Note 3) Find a location in your house where can get the best reception. the digital TV signals are transmitted via a ground-based transmitter. Please place the antenna near the window and away from sheltering buildings as possible as you can for better signal reception. A: Unlike the traditional analog broadcasting that is subject to interference and noise, digital TV transmits and receives pictures and sounds by converting them into digits. currently there are 3 global digital TV standards: DVB-T , ATSC and ISDB. Among them, DVB-T is the most popular standard now, and this TV card supports the DVB-T standard. For more information on DVB, visit the website at www. A: To switch between TV systems, you have to manually change the TV signal sources, and go to [Settings] > [Signal Settings] > [Capture Device] in PowerCinema to change the setting to [713x BDA Digital Capture] or [713x BDA Analog Capture]. Then perform a channel scanning again, and you can watch TV after the scanning is completed. Why can I not watch previous programs after switching channels? a: The recording time limit for using the Time-Shifting function is 30 minutes. This means that only the contents of the latest 30 minutes will be recorded in the hard disk; the contents prior to the 30-minute limit will be automatically erased to allow normal Time-Shifting operations. At least 1GB free hard disk space is recommended for the Time-Shifting function. The Time-Shifting function can only record the contents of the channel that you are currently watching. Once you switch to another channel, the previously recorded contents will be erased and the current contents will be recorded. Q: Why can I not wake up the computer with the remote control after entering the Standby mode?A: To wake up the computer from the Standby mode, press and hold the power button on the remote control for 1 second. It may take 5~10 seconds (depending on the computer status) for the computer to wake up from the Standby mode. In addition, please make sure that the ACPI power management of your computer BIOS is set to S1 mode for the remote control, keyboard or mouse to wake up the computer from the Standby mode. [. . . ] A: To wake up the computer from the Standby mode, press and hold the power button on the remote control for 1 second. It may take 5~10 seconds (depending on the computer status) for the computer to wake up from the Standby mode. In addition, please make sure that the ACPI power management of your computer BIOS is set to S1 mode for the remote control, keyboard or mouse to wake up the computer from the Standby mode. If the setting is S3 mode, you can only wake up the computer from the Standby mode by pressing the power button of the computer. [. . . ]