User manual GIGAFAST EF1600-SI

[. . . ] It can also act as a bridge between 10Mbps and 100Mbps network segments. Thanks to the switching technology, it support 10Mbps and 100Mbps dedicated bandwidth in ev e r y p o r t . T h e de v i c e is b ui lt wit h P l u g & Pl a y, Aut o- Neg ot i at io n on all port s, as well as Hal f And Fu l l Dupl ex O per at i o n, St or ean d- F or w ar d an d C ut - T hr o ugh t r ans m i ss io n mode for easy installation and smooth transition from legac y 10 M bps t o 10 0Mb ps . [. . . ] One up link p ort (shared with port 1) to facilitate your network expansion. To ensure maximum safety and good function please read carefully and follow all the directions in this manual to get successful Installation and operation. Package Contents The EF1600-SI package includes: 1 Switch, EF1600-SI This user's manual 1 AC power cord 4 rubber foot stands Mounting the Switch Before installing the switch EF1600-SI, be sure to find suitable location around the center of the devices you want to link, and near a power outlet. Place the hub on any convenient flat surface, such as a desktop or nearby shelf. For more stability, you may put 4 rubber foot stands on the bottom side of EF1600-SI, if necessary. Attach Computers to the Switch Ports 1. Install a 10/100Mabps (10/100Base-TX) network adapter card and driver in every computer you want to network. Prepare twisted-pair cables with RJ-45 plugs. Use Category 5/5e cable for all connections. Make sure that the cable length is less than or equal to 100 meters (328 feet). Attach one end of the cable to the RJ-45 port of the computer 's network adapter card and the other end to any available port of the switch EF1600-SI. Check the power outlet by plugging in another device that functions properly. Or check the power cord with another device. The LED's, except the power one, don't light down after Power on. Power on again. Cause: Solution: Symptom: Cause: Solution: Symptom: Cause: Solution: LNK/ACT LED does not light up after proper connection. Network interface (e. g. , a network adapter card on the Attached device), network cable, or switch port is defective. Verify that the switch EF1600-SI and the attached device are powered. Be sure the cable is correctly plugged into both the switch EF1600-SI and the corresponding device. Verify that the proper cable type is used and its length is not more than 100 meter (328 feet ). [. . . ] Be sure the cable is correctly plugged into both the switch EF1600-SI and the corresponding device. Verify that the proper cable type is used and its length is not more than 100 meter (328 feet ). Check cable connection and the power cord for possible defects. [. . . ]