User manual GMC LS1620

[. . . ] 200W VARIABLE SPEED SCROLL SAW ® WITH REDEYE LS1620 INSTRUCTION MANUAL 1 Black Cyan Magenta Yellow Code: LS1620 Date: 060906 Edition: 05 Op: BR Contents Introduction Environmental protection Description of symbols Specifications Safety rules for laser lights General safety instructions Additional safety rules for scroll saws Accessories Unpacking Assembly Know your product Mounting the saw to a workbench Blades Selecting the correct blade Removing blades Installing blades Setting the table for horizontal or bevel cutting Aligning the degree scale pointer Turning on and off Sawdust blower LED light Adjusting the laser line Adjusting the speed Selecting the correct speed Scroll saw operation Using the REDEYE® laser line generator Maintenance Oiling the arm bearings Cleaning General inspection Repairs 3 3 3 3 4 4 5 6 6 6 7 8 8 8 8 9 9 9 10 10 10 10 11 11 11 12 12 12 12 13 13 Warranty Powertools Whilst every effort is made to ensure your complete satisfaction with this tool, occasionally, due to the mass manufacturing techniques, a tool may not live up to our required level of performance and you may need the assistance of our service department. This product is warranted for a 2-year period for home domestic use from the date of the original purchase. If found to be defective in materials or workmanship, the tool or the offending faulty component will be repaired or replaced free of charge with another of the same item. We reserve the right to reject any claim where the purchase cannot be verified. [. . . ] Only feed the material fast enough so that the blade will cut. · Use caution when cutting off material which is irregular in cross section as it could pinch the blade before the cut is completed. A piece of moulding, for example, must lay flat on the table and not be permitted to rock whilst being cut. · Use caution when cutting off round material such as dowel rods or tubing. They have a tendency to roll while being cut causing the blade to bite. · Never leave the scroll saw running unattended. Using the base of the scroll saw as a template mark the holes on the workbench through the holes in the casting. Drill the holes through the workbench using an 8mm drill bit. Bolt the saw to the workbench using bolts, washers and nuts. The fasteners are not supplied with the machine. A soft foam pad or carpet (not supplied) can be placed between the scroll saw and the work bench to further reduce noise and vibration. 7. Most blade packages state the size or thickness of wood which that blade is intended to cut, and the radius (size of curve) which can be cut with that blade. Wider blades cannot cut curves as tight or small as thinner blades. This saw uses 127mm long pin type and flat blades. Cutting plywood which is very abrasive b. Cutting wood that is thicker than 19mm c. Side pressure is placed on the blade Removing blades CAUTION. Always ensure that the saw is switched off and unplugged from the mains supply before removing or installing a blade. Lift up the blade tension lever (12) to reduce the blade tension. Remove the table insert (11) by raising it with a screwdriver. Loosen the upper and lower blade adapter knobs (14). Remove blade from the upper and lower blade adapters (13). Blades The scroll saw accepts 127mm pin type and flat blades. [. . . ] Switch on the laser beam using the laser light on/off switch (2). Line up the laser line with the line on the workpiece 6. To begin the cut guide the wood into the moving saw blade. Maintenance WARNING. Always ensure that the tool is switched off and the plug is removed from the power point before making and adjustments or maintenance procedures. [. . . ]