User manual GN NETCOM GN CONTOUR LX-G

[. . . ] Your headset is now ready to wear. Figure 2 LX-G Tube Assembly Wearing To wear the Contour LX-G headset, pivot the earhook behind your ear so that the saddle of the hook rests on the top of your ear. With your thumb, close the ear lobe hinge until it is snug, secure and comfortable to wear, but not tight on your ear (see Figure 3). Finally, insert the eartip into your ear canal. Refer to the Microphone Positioning section for additional information. Changing Ears To accommodate left or right ear wearing styles, rotate the microphone boom 180° so that the side of the microphone marked with an F is facing towards you. [. . . ] The modular connector plugs directly into a headset port (modular jack) on the telephone or console. The modular plug cable also has a mated Quick Disconnect assembly (see Figure 9). Disconnecting at the Quick Disconnect allows you to move around without having to remove your headset. If you are on a call, disconnecting at the Quick Disconnect effectively puts the other party on hold until you return. Netc om e mut t dse hea off on off on me volu high Figure 8 Amplified Configuration low Maintenance The foam covers on the receiver and microphone can be washed in mild soap and water. Replacement covers are available from your GN Netcom distributor. Figure 9 Unamplified Configuration 3 Cautionary Notes to Computer Users When using any headset with a computer, care should be taken in dry or low humidity environments to protect the user from electrostatic discharge from the monitor (CRT). Computer monitors can induce a substantial electrostatic charge when turned on or off, or when there is a power failure, and the resulting electrostatic discharge can be passed through the headset to ground. A user in close proximity to or touching the computer may feel a common "shock" sensation, similar to touching a doorknob after walking across a carpet, causing no harm to the user. This discharge is entirely due to the computer monitor; the headset is merely the shortest path to ground. To minimize the possibility of electrostatic discharge through the headset, you can: · Use a grounded screen in front of the monitor. · Use static dissipative wrist straps. · Increase the relative humidity in the room to 60% or more. · Install static dissipative carpets or floor coverings (anti-static sprays can be helpful). · Remove the headset before turning the computer on or off. Profile headsets meet all OSHA, UL, FCC and CSA standards. FCC Notice to Users Upon request only, you must notify your telephone utility company (telco) of your intention to install or permanently remove an FCC Part 68 registered device or system. Include the FCC Registration Number and the Ringer Equivalence Number (REN) located on the amplifier label. The telco has the right to make changes to their network, which may affect the operation of your equipment, provided you are given adequate advance written notice to permit correct operation. Warranty GN Netcom, Inc. warrants these products against all defects in material and workmanship for a period of two years from the date of original purchase. The conditions of this warranty and our responsibilities under this warranty are as follows: · The warranty is limited to the original purchaser. · The warranty is void if the serial number, date code label or product label is removed, or if the product has been subject to physical abuse, improper installation, modification, or repair by unauthorized third parties. 4 · The responsibility of GN Netcom, Inc. under this warranty shall be limited to the repair or replacement of the product at the sole discretion of GN Netcom, Inc. [. . . ] Include the following with the product: · Your name, company name, address and telephone number. · A copy of the receipt or other proof of purchase (without proof of purchase, your warranty will be defined as beginning on the date of manufacture as labeled on the product). Or, for out of warranty products: · A purchase order which authorizes repair. In warranty products are warranted for one year from the repair date or for the remainder of the original warranty period, whichever is longer. [. . . ]