User manual GN NETCOM ORATOR-G

[. . . ] Refer to the Microphone Positioning section for additional information. Figure 3 Headband Wearing Changing Ears To accommodate left or right ear wearing styles, bend the microphone boom at the hinge beneath the receiver (see Figure 4). Do not force the microphone boom beyond the built in stops! Figure 4 Changing Ears 1 Microphone Positioning To take advantage of the noise canceling qualities of the microphone, position the Orator-G headset with the flat side of the microphone, marked with an F , facing you. The microphone boom should be adjusted so that the microphone is approximately one finger width away from your lower lip (see Figure 5). The Orator-G has a flexible boom that can be reshaped until the microphone is correctly positioned in front of your mouth. [. . . ] If you are on a call, disconnecting at the Quick Disconnect effectively puts the other party on hold until you return. om Netc mut hea dse t e off on off on high volu me Figure 8 Amplified Configuration low Maintenance The foam covers on the receiver and microphone can be washed in mild soap and water. Replacement covers are available from your GN Netcom distributor. Figure 9 Unamplified Configuration 3 Cautionary Notes to Computer Users When using any headset with a computer, care should be taken in dry or low humidity environments to protect the user from electrostatic discharge from the monitor (CRT). Computer monitors can induce a substantial electrostatic charge when turned on or off, or when there is a power failure, and the resulting electrostatic discharge can be passed through the headset to ground. A user in close proximity to or touching the computer may feel a common "shock" sensation, similar to touching a doorknob after walking across a carpet, causing no harm to the user. This discharge is entirely due to the computer monitor; the headset is merely the shortest path to ground. To minimize the possibility of electrostatic discharge through the headset, you can: · Use a grounded screen in front of the monitor. · Use static dissipative wrist straps. · Increase the relative humidity in the room to 60% or more. · Install static dissipative carpets or floor coverings (anti-static sprays can be helpful). · Remove the headset before turning the computer on or off. Profile headsets meet all OSHA, UL, FCC and CSA standards. FCC Notice to Users Upon request only, you must notify your telephone utility company (telco) of your intention to install or permanently remove an FCC Part 68 registered device or system. Include the FCC Registration Number and the Ringer Equivalence Number (REN) located on the amplifier label. The telco has the right to make changes to their network, which may affect the operation of your equipment, provided you are given adequate advance written notice to permit correct operation. Warranty GN Netcom, Inc. warrants these products against all defects in material and workmanship for a period of two years from the date of original purchase. The conditions of this warranty and our responsibilities under this warranty are as follows: · The warranty is limited to the original purchaser. · The warranty is void if the serial number, date code label or product label is removed, or if the product has been subject to physical abuse, improper installation, modification, or repair by unauthorized third parties. 4 · The responsibility of GN Netcom, Inc. under this warranty shall be limited to the repair or replacement of the product at the sole discretion of GN Netcom, Inc. · Any implied warranty on GN Netcom, Inc. [. . . ] Include the following with the product: · Your name, company name, address and telephone number. · A copy of the receipt or other proof of purchase (without proof of purchase, your warranty will be defined as beginning on the date of manufacture as labeled on the product). Or, for out of warranty products: · A purchase order which authorizes repair. In warranty products are warranted for one year from the repair date or for the remainder of the original warranty period, whichever is longer. [. . . ]