User manual GOLDEN STATE INTERNATIONAL 40-319

[. . . ] - modello - model - modèle - modell - model - modelo - modelo             - numero di serie - serial number - numéro de série - modellnummer - serienummer - número de serie - número de série         3 Kundendienst Bevor Sie sich an den Kundendienst wenden: • Prüfen Sie, ob die Störung selbst behoben werden kann (siehe Störungen und Abhilfe). U moet doorgeven: • het type storing • het model apparaat (Mod. ESTAMOS A SU SERVICIO - modello - model - modèle - modell - model - modelo - modelo             4 - numero di serie - serial number - numéro de série - modellnummer - serienummer - número de serie - número de série         Assistência Antes de contactar a Assistência técnica: • Verifique se pode resolver sozinho a anomalia (veja as Anomalias e Soluções). ON/OFF The entire product (both the refrigerator and freezer compartments) may be switched on by pressing this button for 2 seconds. [. . . ] € The appliance comes with a motor protection control system which makes the compressor start approximately 8 minutes after being switched on. The compressor also starts each time the power supply is cut off whether voluntarily or involuntarily (blackout). If the word “OK” does not appear it means that the temperature is too high: adjust the REFRIGERATOR OPERATION knob to a higher position (colder) and wait approximately 10 hours until the temperature has been stabilised. Check the indicator light again: if necessary, readjust it following the initial process. If large quantities of food have been added or 25 GB if the refrigerator door has been opened frequently, it is normal for the indicator not to show OK. Wait at least 10 hours before adjusting the REFRIGERATOR OPERATION knob to a higher setting. AIR * It is recognizable due to the presence of the mechanism on the top part of the refrigerator compartment (see diagram). B Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: 1. Press the ON/OFF button to switch off the appliance. If this procedure is not followed, the alarm may sound. This alarm does not indicate a malfunction. The function is activated by pressing and holding the super freezer and FRZ (+) buttons simultaneously for at least 6 seconds. Once the function has been activated, all LEDs will light up for 2 seconds to confirm activation, and the temperature setting of +5, -18 will appear on the display. The display switches off after 5 seconds. To change the temperature, simply press the + and – buttons until you have reached the desired temperature. However, the I Care function can also be disabled by switching the product off using the ON/OFF button. When it is switched back on, the I Care will be disabled. In humid environments, when the I Care function is enabled, slight condensation may form on the appliance door; normal operating conditions are restored when the function is disabled. Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. € The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. [. . . ] € The refrigerator or the freezer have been over-filled. The food inside the refrigerator is beginning to freeze. € The temperature that has been set is too low (see Start-up and use). • The function SUPER FREEZE has been enabled • The door is not closed properly or is continuously opened. [. . . ]