User manual GOLDEN STATE INTERNATIONAL 40-879

[. . . ] 3 INCREASE POWER button switches on the hotplate and controls the power (see Start-up and use). 4 REDUCE POWER button controls the power and switches off the hotplate (see Start-up and use). 5 COOKING ZONE SELECTED indicator shows a particular cooking zone has been selected and therefore various adjustments are possible. 6 POWER indicator provides a visual display for the current heat level. [. . . ] The fan functions at maximum power when the large induction element is at maximum power or when the booster function is on; in all other cases, it works at average power depending on the temperature detected. Furthermore, the fan may continue to work even after switching the hob off, if the temperature detected is high. The types of noise listed above are due to induction technology and are not necessarily operational faults. - + Booster function* The booster function for some of the cooking zones may be used to shorten heating-up times. The indicator light directly by pressing the above the button will illuminate. This function boosts the power to 2000 W or 3000 W, depending on the size of the relevant cooking zone. The booster stops automatically after 4 minutes. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). For further information, please refer to the Technical description of the models. Booster Switching off the cooking zones To switch off a cooking zone, select it using the corresponding selector button and: • Press the button: the power of the cooking zone will progressively decrease until it is switched off. Switching off the hob Press the button to switch off the appliance - do not rely solely on the pan sensor. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. €Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. and buttons simultaneously • Press and hold the for 6 seconds. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. At step 2, press the button: the duration decreases progressively until it reaches 0 and switches off. The programme resets and the display exits programming mode. - + - + and Timer The hob must be switched on. The timer can be used to set a duration up to 99 minutes. [. . . ] € Do not place tea towels or pot holders over the oven handle. € Turn the SELECTOR knob to the “0” position. If the oven is too hot, the pyrolytic cycle may not start. The programme may only be started once the oven door has been closed. [. . . ]