User manual GRACO FEED PUMP KITS 309815M

[. . . ] Instructions - Parts Feed Pump Kits Not for use in explosive atmospheres. Important Safety Instructions Read all warnings and instructions in this manual. See page 2 for a list of feed pump kits. 309815M ENG Supply polyurethane materials from 55 gal. (200 liter) drums to ReactorTM Proportioner. For professional use only. 246655 Feed Pump Package shown installed in Reactor proportioning system. [. . . ] Installation 6 309815M Installation 5. Connect fluid supply kit a. Install swivel union (102) in pump fluid outlet. Triton 308 only: Install 90° elbow (104) in pump outlet, then install swivel union (102) in elbow. 3 7. Ground system WARNING Read warnings, page 4. Used on Triton 308 packages only. a. 104 3 Feed pump: follow instructions in separate feed pump manual, supplied. 102 b. d. TI3513a Reactor: see Reactor operation manual. Spray gun: see gun manual. Fluid supply containers: follow your local code. b. Connect hose (103) between swivel union (102) and Reactor swivel inlet (D). f. Object being sprayed: follow your local code. Solvent pails used when flushing: follow your local code. Use only metal pails, which are conductive, placed on a grounded surface. Do not place pail on a nonconductive surface, such as paper or cardboard, which interrupts grounding continuity. 6. b. Supply clean, dry, filtered air to feed pumps. See manual 309827 to install air supply kit. g. To maintain grounding continuity when flushing or relieving pressure, hold a metal part of spray gun firmly to the side of a grounded metal pail, then trigger gun. 309815M 7 Installation Husky 1050 Wall Mount 1. Be sure wall can support weight of pump, hoses, and accessories, and can withstand stress during operation. Position wall bracket (204) no more than 5 ft (1. 52 m) above floor. Attach to wall, using screws long enough to keep bracket from vibrating. Connect swivel union (205) to pump inlet. Install pump (201) on bracket (204) securely, using screws (211), washers (210), and nuts (212). Connect elbow (206) to top of riser tube kit (202). Connect suction hose (203) to elbow (206) and inlet swivel (205). Follow steps 1-7, pages 5-7, to finish installation. Standard 2:1 Kit 1. Screw bung adapter with gasket into bung hole. Install swivel fitting (1c) in pump fluid outlet. Connect hose (1b) between swivel fitting (1c) and Reactor swivel inlet (D, see FIG. bushing supplied with desiccant dryer (6, see FIG. Screw dryer 3/4 npt fitting into vent of A component (ISO) drum. [. . . ] With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective. This warranty applies only when the equipment is installed, operated and maintained in accordance with Graco's written recommendations. This warranty does not cover, and Graco shall not be liable for general wear and tear, or any malfunction, damage or wear caused by faulty installation, misapplication, abrasion, corrosion, inadequate or improper maintenance, negligence, accident, tampering, or substitution of non-Graco component parts. Nor shall Graco be liable for malfunction, damage or wear caused by the incompatibility of Graco equipment with structures, accessories, equipment or materials not supplied by Graco, or the improper design, manufacture, installation, operation or maintenance of structures, accessories, equipment or materials not supplied by Graco. [. . . ]