User manual GRACO TANK LEVEL MONITOR 309500L

[. . . ] Instruction Manual Tank Level Monitor Part No. 119274, Series D, North America (N. A. ) Part No. 120105, Series D, (Australia) Used to monitor tank levels for oils and anti-freeze mixtures. The Tank Level Monitor is to be used only with Graco Matrix Software. [. . . ] npt port (D) can be used to accommodate the breather. The breather should be mounted in an upright position using a 90° elbow fitting. Do not use the horizontal port for routing pressure relief return tubes. This can result in inaccurate readings. · 1. bung fitting and screw in the TLM hand-tight. DO NOT use a wrench to tighten as this may damage the TLM. Do not use thread lock adhesive as this may damage the TLM. The TLM must be mounted within 2 degrees of the surface of the fluid. A level that measures degrees should be used. Place the level on the top of the pipe fitting on the tank. If outside the 2 degree specification, the fitting should be changed. Graco recommends that the height of the tank fitting should not exceed 1/2 in. (5. 08 cm), provided the fitting is within 2 degrees of the surface of the fluid. Also, the taller the tank, the more critical the 2 degree specification becomes. CAUTION The TLM will not operate correctly if tilted more than 2° from the surface of the tank liquid. The TLM will not read properly when the fluid in the tank is agitated (i. e. filling a tank with oil or anti-freeze). Be sure to take all TLM readings when the fluid in the tank is calm. D TI4794A FIG. When this happens the Matrix software displays a pop-up screen instructing the administrator to re-boot the Matrix PC. This changes the Matrix clock to match the PC clock. The first TLM reading will be 1 hour earlier or later (depending on the Spring or Fall daylight saving time change), but all subsequent TLM reading will be accurate. 10 309500L Viewing Data Viewing Data Press and release the blue display button (A). Displays appear (B), each lasting a few seconds before going on to the next screen. [. . . ] (360 in. ) Maximum Length Unlimited 16 309500L Dimensions Dimensions A B 9. 1 in (231 mm) 4. 9 in. npt TI4631A 309500L 17 Graco Standard Warranty Graco warrants all equipment manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twenty-four months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective. This warranty applies only when the equipment is installed, operated and maintained in accordance with Graco's written recommendations. [. . . ]