User manual GRANDSTREAM HT386

[. . . ] Grandstream Networks, Inc. HT­386 Dual FXS Port Analog Telephone Adaptor HT­386 User Manual Firmware Version 1. 0. 3. 64 www. grandstream. com support@grandstream. com TABLE OF CONTENTS HT­386 USER MANUAL WELCOME . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Safety Compliances. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 INSTALLATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The maximum password length is 25 characters. Local area code for North American Dial Plan. This field defines the layer 3 QoS parameter which can be the value used for IP Precedence or Diff-Serv or MPLS. Other VLAN supported equipments required if configured these settings. User can short or extend that depends on digits dialed IP address or Domain name of the STUN server. The interval of sending dummy UDP packet to keep NAT "pin hole" open. Firmware upgrade may take up to 10 minutes depending on network environment. Do not interrupt the firmware upgrading process. IP address or domain name of firmware server. IP address or domain name of configuration server. If configured, HT-386 will request the firmware file with the prefix. It should be 32 digit in Hexadecimal Representation. · Bellcore (North America) · CID (Canada) · DTMF (Brazil) · DTMF (Sweden) · DTMF (Denmark) HT-386 User Manual Firmware 1. 0. 3. 64 Page 21 of 34 Last Updated: 2/2007 Home NPA Layer 3 QoS Layer 2 QoS No Key Entry timeout STUN Server Keep-alive interval Use NAT IP Firmware Upgrade and Provisioning Firmware Server Path Config Server Path Firmware File Prefix Firmware File Postfix Config File Prefix Config File Postfix Automatic Upgrade Firmware Key Caller ID Scheme Grandstream Networks, Inc. Onhook Voltage Polarity Reversal NTP server Syslog Server Syslog Level · ETSI-DTMF (Finland, Sweden) · ETSI-FSK (France, Germany, Norway, Taiwan, UK-CCA) Select the onhook voltage to suit different area or PBX. If set to Yes, polarity will be reversed upon call establishment and termination. URI or IP address of the NTP (Network Time Protocol) server, which the HT386 will use to synchronize the date/time. The IP address or URL of syslog server, especially useful for ITSP (Internet Telephone Service Provider) Select the ATA to report the log level. The level is either one of DEBUG, INFO, WARNING or ERROR. Syslog messages are sent based on the following events: · · · · · · · · · · product model/version on boot up (INFO level) NAT related info (INFO level) sent or received SIP message (DEBUG level) SIP message summary (INFO level) inbound and outbound calls (INFO level) registration status change (INFO level) negotiated codec (INFO level) Ethernet link up (INFO level) SLIC chip exception (WARNING and ERROR levels) memory exception (ERROR level) The Syslog uses USER facility. In addition to standard Syslog payload, it contains the following components: GS_LOG: [device MAC address][error code] error message Here is an example: May 19 02:40:38 192. 168. 1. 14 GS_LOG: [00:0b:82:00:a1:be][000] Ethernet link is up Grandstream Networks, Inc. HT-386 User Manual Firmware 1. 0. 3. 64 Page 22 of 34 Last Updated: 2/2007 TABLE 10: HT-386 FXS PORT1/FXS PORT2 SETTINGS PAGES DEFINITIONS SIP Server This field contains the URI string or the IP address (and port, if different from 5060) of the SIP proxy server. e. g. , the following are some valid examples: sip. my-voip-provider. com, or sip:my-company-sip-server. com, or 192. 168. 1. 200:5066 IP address or Domain name of Outbound Proxy, or Media Gateway, or Session Border Controller. Used by ATA for firewall or NAT penetration in different network environment. If symmetric NAT is detected, STUN will not work and ONLY Outbound Proxy will work. [. . . ] RTCP Real-time Transport Control Protocol, defined in RFC 3550, a sister protocol of the Real-time Transport Protocol (RTP), It partners RTP in the delivery and packaging of multimedia data, but does not transport any data itself. It is used periodically to transmit control packets to participants in a streaming multimedia session. The primary function of RTCP is to provide feedback on the quality of service being provided by RTP. RTP Real-time Transport Protocol defines a standardized packet format for delivering audio and video over the Internet. [. . . ]