User manual GRASS VALLEY 8964ENC DATASHEET

[. . . ] [. . . ] Typical applications include cost-effective analog VTR interfaces, composite analog production switcher inputs, and analog transmitter feeds. Up to 40 encoders can be housed in only 2 RU of space. Most adjustments to this card can be performed on the module's card-edge controls. The on-screen display capability included with each module greatly simplifies card-edge configuration. 8900V-R J1 J2 SDI Input 1 J3 J4 NTSC/PAL Output 1 NTSC/PAL Output 2 NTSC/PAL Output 2 NTSC/PAL Output 2 SDI Input 2 J5 J6 SDI Input 3 J7 J8 SDI Input 3 Reference Input J9 J10 Loopthru SDI 1 SDI In Timing Video Proc Video Proc Video Proc Video Proc VBI Composite Out Composite Out Composite Out Composite Out NTSC/PAL 1 SDI 2 SDI In Timing VBI NTSC/PAL 2 SDI 3 SDI In Timing VBI NTSC/PAL 3 SDI 4 SDI In Timing VBI NTSC/PAL 4 Looping Reference Input Reference Specifications Supported Frame Types GeckoFlex with 8900V-R GeckoFlex Video rear module, Gecko video frames: 8900TX-V, 8900TF-V, 8900TFN-V Connector: 75 BNC Return loss: >40 dB to 5. 5 MHz Isolation: 60 dB to 5. 5 MHz Ordering Information This module can be mounted in a GeckoFlex frame when ordered with the 8900V-R GeckoFlex Video rear. Power Rating 8. 5 Watts ­ single slot Performance Quantization: 10-bit Response: ±0. 1 dB to 5. 5 MHz Differential phase: <0. 5° Differential gain: <0. 9% RMS SNR: >60 dB to 5. 5 MHz Output phasing: Full frame with frame synchronizer Electrical length: 2. 1 µs Hue: ±22. 5 Operating temperature: 0° to 45°C Relative humidity: 0% to 90% 8964ENC Four-channel SDI to NTSC/PAL encoder with line synchronizer Inputs Number of inputs: Four, one for each encoder Signal type: SMPTE 259M, 10-bit, 270 Mb/s serial component digital Connector: Terminating 75 BNC Return loss: >15 dB to 270 MHz 8964ENC-FS Four-channel encoder with frame synchronizer Reference Input Number of inputs: One NTSC/PAL (required for operation) Signal type: Color black, SMPTE 170M (525 lines) or CCIR Connector: Looping 75 BNC Return loss: >36 dB to 5 MHz Indicators and Controls Indicators: Input video present, reference present, communication active, power, fault Controls: Output gain, luma level, black level, chroma level, hue, filters, vertical blanking, test signal, timing Remote: All indicators and controls via Ethernet Outputs Number of outputs: Four, one for each encoder Signal type: SMPTE 170M for NTSC and CCIR624 for PAL For detailed specifications, installation, and setup instructions see: www. grassvalley. com/docs/modular [. . . ] [. . . ]