User manual GRAUPNER LIPO DISCHARGE PROTECTION 2-14

[. . . ] Keep inflammable objects away from the charging system. The charging leads shouldn't be coiled up during charging!Never leave the charger unattended while it is connected to the mains. This product isn`t designed for use by children under the age of 14, it isn`t a toy! [. . . ] This product isn`t designed for use by children under the age of 14, it isn`t a toy!Check before charging: Are all connections in perfect order, or are there any loose contacts?Don't forget that quick charging of batteries may be dangerous. Charging a battery: While charging, a certain amount of current is being fed into the battery. Batteries should always be attended to while charging them!Flawed or distended batteries may by no means be charged! The battery to be charged should be connected with an original plug for GRAUPNER LiPo batteries. Make sure that all connectors, plugs, and sockets have a good and safe contact. Any interruptions in the charging process, even short ones, may lead to a new start of the charging process, und thus totally overcharge the battery. Lithium-Polymer cells: The LiPo charger 2/3 may only be used for charging LiPo batteries with a nominal cell voltage of 3. Individual markings indicate which materials can be recycled and re-used. You can make an important contribution to the protection of our common environment by re-using the product, recycling the basic materials or recycling redundant equipment in other ways. Remove batteries rom your device and dispose of them at your local collection point for batteries. If you don't know the location of your nearest disposal centre, please enquire at your local council office. First Operation: Connect your LiPo charger 2/3 to the mains (100V-240V AC). LiPo balancer: For maximum safety, you should by all means use a LiPo Balancer Plus, Order No. Using the charger for the first time Charge mode: Connect the red BEC plug of your LiPo Balancer Plus #3064 to the output lead of the LiPo charger 2/3. Then you should connect the white Graupner Balancer plug of the battery to the OUTPUT of the LiPo Balancer Plus, and then the red battery connector to the BATTERY input of the LiPo Balancer Plus, left-aligned. Now you're ready to connect the LiPo Balancer Plus by pressing the MODE/RESET key until the status LED begins to flash. This charging procedure obtains that the battery will be fully (100%) and carefully charged During the charging process the red LED of the LiPo charger 2/3 will be lit. [. . . ] Then you should connect the white Graupner Balancer plug of the battery to the OUTPUT of the LiPo Balancer Plus, and then the red battery connector to the BATTERY input of the LiPo Balancer Plus, left-aligned. Now you're ready to connect the LiPo Balancer Plus by pressing the MODE/RESET key until the status LED begins to flash. This charging procedure obtains that the battery will be fully (100%) and carefully charged During the charging process the red LED of the LiPo charger 2/3 will be lit. Battery charged: As soon as the battery has reached its full (100%) capacity the device will be automatically switched off. [. . . ]