User manual GROTHE MISTRAL 300

[. . . ] Never dismantle the receiver because high voltages may be present! Using the product for Utilisation conforme its intended purpose The corrugated structure on the back of the transmitter and receiver (GL) can be used as a cable duct!In this case remove battery from ce cas enlever la pile caso è necessario diesem Fall Batterie aus transmitter! [. . . ] Please make sure, that receiver E1 had been programmed only with transmitter S1 and receiver E2 only with S2!Transmitter S2 can be integrated in the receiver, as shown in figure 4, if voltage supply is provided by an external power source. If you want to switch off sound and flash of the first receiver completely, please press according to page 7 push T2 several times until only a short "BEEP" can be heard Der Empfänger (ausser plug-in wireless chime ception du gong radio esclusione della versione Steckdosen-Funkgong SG) can be mounted on pour prise de courant SG) può essere SG) kann auf einer a flat surface, suspended SG) peut être placé sur appoggiato su una ebenen Fläche so that it can be removed une surface plane, superficie piana, appeso aufgestellt, wieder again (screw A) or suspendu de façon (foro A) o fissato a parete abnehmbar aufgehängt amovible (vis A) ou bien per mezzo di viti. In this case selon remove batteries from AC/DC la figure 6. Sockets with verticaly Attention: Si la version arranged terminals SG soit insérée dans des (rotated by 90°), the douilles de prise avec les range might be reduced!Selecting the melody, or flashing / single flash light depending on type of equipment (MELODY-function) !In each case, the melody desired is allocated to the transmitter from which the receiver last received a signal. The melody is always played twice in equipment types with flashing / single flash light, the first time without the visual signal, the second time with the visual signal (in order to avoid that You have to look at the bright light during adjustment, only LED 2 flashes in this case as confirmation). Set flashing / single flash light without melody (for versions GL, SG) !If only the flashing / ohne Melodie gewünscht single flash light is required without the wird, so oft Taste T2 melody, press button T2 drücken, bis die LED 2 until LED 2 flashes but blinkt, aber kein Ton zu no sound is heard. Continue pressing button T2 for more than 3 seconds, until LED 2 flashes briefly. Melody and flashing / single flash light, if applicable, are now switched off. The red warning light LED 2 now flashes as a reminder !If the equipment is not to be used for a period of several weeks, we recommend removing the battery, or in the case of the plug-in wireless chime SG, removing the equipment from the socket. [. . . ] Nun sind am Empfänger keine Sender are no longer tuned to thereceiver. Dispose of used batteries correctly in accordance with the regulations in your country!Do not dispose of used batteries in household refuse! [. . . ]