User manual GRUNDIG GV 560 HIFI LE

[. . . ] VIDEORECORDER GV 560 HiFi Limited Edition r r r Installation and Safety Precautions Connecting The Remote Control 2 3 4-5 r TIMER Recording The options 20-24 . 20 Programming with the ShowView system, variant 1 . 22 Checking the occupied TIMER positions . 22 Altering the data of a TIMER position . [. . . ] The recorder is in record stand-by mode. All drive mechanism functions of the recorder are now "locked". ¢ ShowView n- - - - - - - - 0-9 : Enter number : ED/EW/Normal CLEAR : Delete last digit SV/V+ : New Input OK : Confirm number i : Return ! 2 Enter the ShowView number for the desired TV programme using the numbered buttons 1 . . . In case of an error, the last digit of the ShowView number can be deleted using the CLEAR button. !! ¢ The entire ShowView number can be deleted using the SV/V+ button. ¢ · TIMER Recording 21 All you have to do is activate the ShowView system by pressing a button, enter the ShowView number code ­ indicated in the TV magazine ­ and confirm the entry. 3 Confirm the ShowView number using the G button. ­ The recorder transforms the ShowView number into the actual recording data. r Recorder messages These indicate various operating states and errors. The messages appear on the TV screen or in the display on the recorder. r 1 Checking the occupied TIMER positions Press the SET/CHECK button. ­ The » Record Programming « table appears. After a short time the recorder switches the table off automatically and returns to record stand-by mode. ¢ TIMER Recording ! Remaining playing time Dispaly: » Rest « » REST « and the remaining playing time of the cassette. If the » Rest « is negative (­) and marked in red, a cassette with insufficient playing time was inserted, or the sum of all TIMER recording times is too high. r 1 2 Altering the data of a TIMER position Press the SET/CHECK button. ­ The » Record Programming « table appears Select the required TIMER position. To do this, press the SET/CHECK button as often as necessary, until the coloured marker is at the required TIMER position. ¢ Record length Display: » Record length « » REST ­ : ­ ­ «. The cassette playing time was not recognized. 3 ¢ No Cassette Display: » No Cassette « » NO CASSETTE «. 4 Alter data using the B PROG. , B DAY, B START, B STOP buttons. Store the setting using the G button. Cassette Protected Display: » Cassette Protected « » PROTECTED «. The cassette is protected against re-recording. It is ejected automatically. r 1 Deleting an occupied TIMER position Press the SET/CHECK button. ­ The » Record Programming « table appears. To do this, SET/CHECK button as often as necessary, press the until the coloured marker is at the required TIMER position. ¢ Collision Display: » Collision « » COLL «. The affected TIMER positions are marked in red. The recording times of the TIMER positions overlap. Change the entered data of one of the TIMER positions. 2 ¢ 3 ¢ r Erase the data of the TIMER position using the CLEAR button. Code error Display: » Code Error! [. . . ] The video heads are dirty. Tune the TV set correctly to the transmitting channel of the video recorder. Press the TRACKING button during playback and keep it pressed for a few seconds. The video heads are cleaned, the playback picture cannot be seen during this time. ¢ The video heads are worn. Operation with the remote control is not possible. [. . . ]