User manual GRUNDIG MCD 30

[. . . ] How to use the magazine loading a disc Pick the tab on the magazine's disc tray and pull out only one of the trays. press the tab on the disc tray to store the tray back in the magazine. ­ When the magazine is used for the first time, it will not lock into place unless the power supply has been connected. Place the disc on the tray with its play surface facing up (label surface facing down). [. . . ] To prevent a short-circuit: ­ Be sure to turn off the ignition and remove the negative (­) battery cable prior to installation. Before installing the unit position of the built-in anti-vibration board This unit can be installed horizontally (suspended), vertically, and at a 45° angle. Once the installation position has been decided, it's necessary to set the position of the built-in anti-vibration board inside the unit. please do this before perfoming the procedure listed below. Vibration may cause the disc to skip if the unit is used before properly setting the anti-vibration board. ⭠At the time of shipping , the built-in antivibration board is set for horizontal installation "H". ­ The are built-in anti-vibration boards on both the left and right sides. ­ Set the anti-vibration board position with a screwdriver before attaching the brackets. For use when unit is installed horizontally or suspended: Confirm that the built-in anti-vibration board is set to position "H". For use when unit is installed vertically: The built-in anti-vibration board should be set to position "V". For use when unit is installed at a 45° angle: The built-in anti-vibration board should be set to position "45°". 1 ­ Confirm that the built-in anti-vibration boards on both the left and right sides are set to the horizontal installation position "H". ⭠Attach bracket (L) and bracket (R) using the hexagonal bolts (M5 x 8). ­ Attach brackets (L) and (R) to their respective brackets (B) using the hexagonal bolts (M6 x 20) and the hexagonal nuts (M6). 2 ­ Pull back the carpet and determine where to attach the unit. ­ Stick the supplied double-sided tape to the bottom of the brackets (B) and peel off the paper backing. ­ Affix the unit to the floor by pressing in place. 4 ­ Using a knife, cut "X"s in the carpet directly above the brackets (B) bolts. ­ Return the carpet to its original position allowing the bolts to stick through. 3 ­ Remove the hexagonal nuts and take off the changer. 5 ­ Once more, use the hexagonal nuts to attach the changer on top of the carpet. 1 ­ Set that the built-in anti-vibration boards on both the left and the right sides are set to the vertical installation position "V". [. . . ] For this reason, the following table is provided to help you. If the measures listed in the table are not successful, please contact your specialized dealer. Note any fault messages in the display of your car radio. Remedy Replace the fuse with a fuse having the correct current rating. [. . . ]