User manual GRUNDIG MS 6640 HERRENRASIERER, A/N, 3-CUT,1

[. . . ] All rights to claim under the guarantee are invalidated for damage caused by improper interventions. 7 7 7 7 7 7 7 Never immerse the appliance in water. For mains operation, plug the mains adapter cable into the appliance first, then plug the en. qxdmains adapter into the socket. After use, switch off the appliance, disconnect the mains adapter then disconnect the mains adapter cable. 7 7 7 7 7 ENGLISH 21 AT A GLANCE _____________________________________ Fold open page 2 to clearly see the diagrams at all times. Controls A Slide switch for switching on and off. Slide switch for extending out the front detail trimmer for problem zones. [. . . ] It is advisable not to charge the rechargeable batteries after each use. Do not recharge the batteries until they are completely dead. Avoid daily charging. 7 The red LED indicator C flashes, quickly during battery mode, if the batteries need recharging. At the same time, none of the green LED indicators H are lit anymore (MS 8640 and MS 9640 only). 7 7 24 ENGLISH POWER SUPPLY __________________________________ Mains mode (with the mains adapter) The appliance has automatic, worldwide functioning, voltage conversion for 100 ­ 240 V, 50/60 Hz. Check whether the mains voltage given on the rating plate of the mains adapter supplied matches the local mains voltage. The appliance is not disconnected from the power supply until the mains adapter is disconnected. 1 Insert the cable of the mains adapter in the socket G . ­ The installed batteries are switched off. The green LED indicators H flash alternately (MS 8640 and MS 9640 only). Important 7 Only use the appliance next to a water connection if it is in battery mode, never in mains mode. ENGLISH 25 USE ___________________________________________________ Face shave 1 Remove the plastic cover. Important 7 Ensure the foils and blade blocks are not damaged. 2 Switch on the appliance by pressing the slide switch A downwards. 3 Tauten the skin with your free hand and, with slow and gentle movements, pass the appliance against the direction of the beard growth. Hold the appliance at an angle of 90° to the skin. Ensure both foils are in contact with the skin. 4 Do not exert a strong pressure as this could damage the foils. 5 If necessary, use the slide switch to extend out the front detail trimmer. Note 7 Use the detail trimmer to shave difficult to reach parts of the face, e. g. 6 After use, retract the front detail trimmer using the slide switch B . 7 Switch off the appliance at the switch and replace the plastic cover A . 26 ENGLISH USE ___________________________________________________ Trimming using the long hair cutter The long hair cutter cuts longer hair on the face and neck, as well as a beard, moustache or sideburns. 1 Switch on the appliance by pressing the slide switch A downwards. 2 Push up the long hair cutter F (rear of the appliance) until it latches into place. [. . . ] 1 Switch off the appliance and if necessary remove the mains adapter cable from the socket G . Remove the cutting head by pressing on the side fastening pushbuttons D . 2 Pull the blade blocks upward and off their holders. 30 ENGLISH CLEANING AND CARE __________________________ 3 Remove the foil frame element from the holder by simultaneously pressing inwards both side plastic clamps in the cutting head and pushing the holder away to the back. 5 Push the new foil frame element precisely into the holder until the side plastic clamps latch into place on both sides. Note 7 After inserting the foil frame there is a risk of destruction. 6 After replacing the blades, push on the cutting head so that it latches into place on both sides. 4 Place the new blade blocks on their holders. ENGLISH 31 INFORMATION ____________________________________ Environmental information This product has been made from high-quality materials and parts, which are suitable for recycling and can be reused. [. . . ]