User manual GRUNDIG MT 4640 APARADOR BARBA

[. . . ] Mains adapter. B C D Further accessories Cleaning brush. Oil. E F G 18 ENGLISH POWER SUPPLY ___________________________________ Runs on rechargeable batteries If run with the installed rechargeable nickel metal hydride batteries, use the supplied mains adapter J as a charger. Check whether the mains voltage given on the rating plate of the mains adapter matches the local mains voltage. The appliance is not disconnected from the power supply until the mains adapter is disconnected. [. . . ] Therefore, at the end of its life, the product must not be disposed of in the normal domestic waste but must be taken to a collection point for recycling electrical and electronic appliances. This is indicated by the following symbol on the product, in the instructions for use or on the packaging. Please contact your local authority to find out where your local collection points are. Reusing and recycling old appliances is an important contribution to protecting our environment. 20 ENGLISH USE ___________________________________________________ Function 1 Trim beard . . . . . . using the wide blade side B and the telescopic comb attachment H . 2 Carefully push comb attachment H onto the blade until it latches into place. The numbers on the telescopic comb attachment must be visible on the back of the appliance. Please note that you can only use the telescopic comb attachment if you are using the wide blade side B . 3 Set the required beard length after cutting at the cutting length adjustment switch I of the telescopic comb attachment. The numbers 2, 4, 6, 8, 10 are values in millimetres. 4 Now switch on the appliance with switch A and start cutting your beard. Move the appliance against your beard's direction of growth and ensure the telescopic comb attachment remains in contact with your skin at all times. Do not move the appliance too fast. Function 2 Trim beard . . . . . . using the narrow blade side C without the telescopic comb attachment. Please note, in this mode you cannot use the telescopic comb attachment H supplied with the appliance!The narrow blade side is for precise use on small areas. ENGLISH 21 USE ___________________________________________________ 1 Ensure the appliance is switched off. 2 Remove comb attachment: Release the comb attachment by gently pressing both fingers on the side release buttons and then lift it from the top. 3 Remove blade: Hold the blade or attachment on its sides and turn it to the left until it releases. 4 Attach blade: Rotate the blade by 180° to the new cutting position. Fit the blade into the housing and lock it by moving gently to the right while gently pressing down. 1 2 Important 7 Risk of injury!When adjusting the blade, please ensure you do not accidentally switch on the appliance at switch A . 22 ENGLISH USE ___________________________________________________ Useful tips 7 General Vacuum system 7 The appliance is equipped with an advanced vacuum system. As soon as you switch on the appliance the vacuum suction system is activated hair and trimmed hairs are hygienically collected in the collection chamber D . 7 Use the appliance with a relaxed and comfortable grip. [. . . ] Important 7 Never hold the appliance, cable or mains adapter in water or any other liquid. 4 Before using again, ensure all parts have been carefully dried with a soft cloth. Note 7 Remove hair remains after each use. 7 Your appliance's blade does not normally have to be oiled, as it is made from a combination of two different materials (ceramic and stainless steel). If you want to retain the original condition of the blade for a long time, it is worthwhile oiling the blade at regular intervals using the oil supplied. Storage If you are not going to be using the appliance for a lengthy time, please store it carefully. [. . . ]