User manual GRUNDIG RRCD 3410

[. . . ] RADIO CASSETTE RECORDER WITH CD RRCD 3410 ENGLISH OVERVIEW ______________________________________________________ Controls General information CD TAPE/OFF RADIO ON Z VOLUME UBS 0 Switches between the CD, TAPE and RADIO input sources. Infrared receiver for the remoter control. Switches the Ultra Bass System on and off. Headphone jack for connecting a headphone set with a jack plug (ø 3. 5 mm) on the left side of the device. [. . . ] Clean the device with a clean, moist leather cloth. Please note when deciding where to put the device that furniture surfaces are covered by various types of lacquer and plastic, most of which contain chemical additives. These may cause corrosion to the feet of the device, thus resulting in stains on the surface of the furniture which can be difficult or impossible to remove. General information on laser devices You will find a symbol similar to the one shown here on the bottom of the device. CLASS 1 LASER PRODUCT CLASS 1 LASER PRODUCT means that the laser is designed in such a way as to ensure that the maximum permissible emission value cannot be exceeded under any circumstances. If operating devices or methods other than those specified here are employed, it may lead to dangerous exposure to emissions. Invisible laser radiation is emitted if the CD compartment is opened and the safety locking mechanism is shorted. Do not expose yourself to this radiation. 23 ENGLISH GENERAL FUNCTIONS __________________________________ Switching on and off 1 2 Switch on the device with the required input source by moving the switch to the »CD TAPE/OFF RADIO« position. To switch off the device, move the »CD TAPE/OFF RADIO« switch to the »TAPE/OFF« position and turn off the tape drive if necessary. Selecting the input source 1 Select the input source (CD, TAPE or RADIO) using »CD TAPE/OFF RADIO«. Adjusting the volume 1 Adjust the volume with »VOLUME«. Switching the Ultra Bass System on and off This function boosts the bass frequencies. 1 Switch the Ultra Bass System on and off with »UBS«. Listening with headphones 1 Connect the headphones to the »0« headphone jack (ø 3. 5 mm). ­ This switches off the loudspeakers. RADIO MODE _________________________________________________ Antennas 1 For FM stations (VHF) extend the telescopic antenna. Note: If the FM signal is too strong, it is advisable to push in the telescopic antenna. 2 The radio recorder has a built-in rod antenna for MW reception. Turn the radio recorder about its own axis to point the antenna. Selecting the radio input source 1 Move the »CD TAPE/OFF RADIO« switch to the »RADIO« position. Setting and storing radio stations Automatic station search 1 2 Select the frequency band (FM or MW) using »STOP/BAND«. Activate the station search by pressing »PROG/MEM« until the frequency display changes to rapid run-through. ­ The device searches for up to 10 radio stations and then saves them. After the search has finished, the station stored in position 01 can be heard. 24 RADIO MODE _________________________________________________ Automatic station search 1 2 Select the frequency band (FM or MW) using »STOP/BAND«. Activate the station search by pressing »DOWN/F. RW 8« or »UP/F. FW 9« until the frequency display changes to rapid run-through. ­ The search stops when a programme is found. Manual station search 1 To move the frequency forward in steps, briefly press »DOWN/F. RW 8« or »UP/F. FW 9« several times. An adapter is not necessary. Selecting the CD input source 1 2 3 4 Move the »CD TAPE/OFF RADIO« switch to the »CD« position. Press »OPEN/CLOSE« to open the CD compartment. Insert a CD in the compartment with its label facing upwards. Press »OPEN/CLOSE« to close the lid of the CD compartment. ­ The device reads the content of the CD. The total number of tracks appears in the display. CD playback 1 Press »PLAY/PAUSE II« to start playback. [. . . ] ­ The CD automatically pauses at the end of the tape. Turn over the tape and press » · 5 ·« to resume recording. CD synchro recording 1 2 3 Insert a tape with the protection tabs intact and find the desired tape position by pressing » « or » «. Move the »CD TAPE/OFF RADIO« switch to the »CD« position. Press » « to start recording. [. . . ]