User manual GRUNDIG T 55-730/5 TEXT/ICN

[. . . ] Even if your television is switched off, it can still be damaged by lightning striking the mains and/or aerial cables. For this reason, you should always disconnect your television from the mains and the aerial system during thunderstorms. Do not insert foreign objects into the ventilation openings at the back. Connect the mains lead to the wall socket. [. . . ] Enter the channel number (in the case of a special channel, enter »C« instead of »S« with the P+ button). If the channel number 00 is entered on a programme position, all further positions can no longer be selected with the P+ and P- buttons. Standard (television standard); select »BG« with PAL transmissions, »DK« with SECAM transmissions »NT« with NTSC transmissions. When storing is completed, the programme data of the next programme position is displayed. Automatic frequency fine tuning on/off: press i, OK, i, i, then select with ­ . »DEC«If an encoded programme is assigned to this programme position and an appropriate descrambler (decoder) is connected, then select »ON«. »FT« If fine tuning is necessary after programme assignment, press the ­ button until the figures below FT get green. Press the P+ or P­ button until the best picture quality is obtained. Select the function with the ­ or + button and call it up with OK. The functions 1, 3, 4, and 5 can be executed without calling up the dialogue line as follows: 1 3 4 5 You can select pages without entering the page numbers. you can select the desired Teletext page in overview pages (pages containing three-digit page numbers). This function saves you entering the three-digit page numbers. Use the P+ or P­ button to move the cursor to the desired page number. Connect the video recorder or satellite receiver with an AV cable to the AV socket at the back of the set. When connecting a decoder (descrambler), pay attention to the chapter on page 8: » Manual setting of program positions. « In the menu, the "ON" setting must be used at the corresponding program position under » DEC «. This unit conforms to VDE safety regulations and directives of the Deutsche Bundespost (German Federal Post Office; see certification mark on the type sticker on the rear of the unit), as well as all relevant ordinances governing X-ray emissions. The picture tube, which emits X-rays, is sufficiently shielded and therefore represents no danger. [. . . ] If a non-rewireable plug or a rewireable 13 Amp (BS 1363) plug is used, it must be fitted with a 5 Amp ASTA or BSI approved BS 1362 fuse. If any othe type of plug is used it must be protected by a 5 Amp fuse either in the plug or at the distribution board. Important: The wires in the mains lead are coloured in accordance with the following code: As the colours of the wires in the mains lead of your appliance may not correspond with the coloured marking identifying the terminals in your plug, proceed as follows: Connect the BLUE coloured wire to plug terminal marked with the letter "N" or coloured black. Connect the BROWN coloured wire to the plug terminal marked with a letter "L" or coloured red. [. . . ]