User manual GTO TRANSMITTER

[. . . ] Press and hold the LEARN TRANSMITTER button on the control board for 5 seconds or until the buzzer sounds. Release the LEARN TRANSMITTER button on the control board. FM700/702/1000/2000 On the gate opener control board locate the LEARN button. Press and hold the LEARN button on the control board, and turn the power switch ON. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. INSTRUCTIONS FOR DUAL BUTTON TRANSMITTERS The two button transmitter is used for the remote control of two gate openers or a gate opener and a garage door opener. Remove the Transmitter Cover Open the transmitter by removing the two screws on each side of the spring clip on the back of the transmitter. This will expose the battery and the dip switches. The code can now be changed using a small screwdriver. IMPORTANT: If you already have a transmitter that operates your gate and are simply adding an additional transmitter, set the DIP switches in the new transmitter to match your old one and you are done. 2. Setting New Code There are eight (8) dip switches, each of which can be placed in three different positions (+, 0, -). DO NOT set all switches in the same position, such as all +, all -, or all zeros. WARNING: No other adjustments should be made inside the transmitter. Now that your have selected your personal code, reassemble the transmitter. MM500/502/250/350 and PRO-SW3000/4000/ On the gate opener control board locate the LEARN TRANSMITTER button. Press and hold the LEARN TRANSMITTER button on the control board for 5 seconds or until the buzzer sounds. Release the LEARN TRANSMITTER button on the control board. FM700/702/1000/2000 On the gate opener control board locate the LEARN button. Press and hold the LEARN button on the control board, and turn the power switch ON. Wait 15 seconds for the receiver to charge. Press and hold transmitter button until the red STATUS LED comes ON. The new code is stored in control board memory. [. . . ] The manufacturer will not be responsible for any charges or damages incurred in the removal of the defective parts for repair, or the reinstallation of these parts after repair. Use of any components that are not GTO® specified (e. g. battery or transformer) will void the warranty. This warranty shall be considered void if damage to the product(s) was due to improper installation or use, use of non-GTO® specified or approved components or replacement parts, connection to an improper power source, or if damage was caused by lightning, wind, fire, flood, insects, or other natural agents. [. . . ]