User manual H2O AUDIO IN3-5A3

[. . . ] To install a new or clean T-Seal, start at any corner, push the T-Seal into the corner and run your finger along the T-Seal pushing it into the Case Contact Surface. Ensure the T-Seal is seated properly in all four corners of the Cases Contact Surface. How to install / replace the T-Seal 5. The lid should close without any resistance. If you experience any resistance when closing the case please call customer service immediately at 1. 800. 708. 6080 before using the case. [. . . ] Align the audio port with the stereo jack in the case. IMPORTANT: Remove any skins or covers from your iPod before installing it into the housing. 2. Gently snap the player into the audio jack. Verify the player is completely plugged into the audio jack. 1. While holding the latch button towards the unlock icon, push away from the case to open the latch. 1. T-Seal is twisted or out of alignment during closure. Compatible with iPod nano (3rd Gen) 2. Pull the latch towards the case and snap close. Contact Surface of the lid prior to closure. Removing the iPod 1. Slide the player off of the stereo jack. Now the player can slide straight out of the case. 2. T-Seal and contact surface have been cleaned as necessary using a soft, lint-free cloth. 2. T-Seal and Contact Surfaces have any dirt, lint, hair, and/or other debris. 3. T-Seal and Contact Surface are free of scratches and other imperfections. 3. You see scratches or imperfections on the T-Seal or Contact Surfaces. 3. Verify the lid & latch are closed 3. Unhook the buckle from the base. with the button positioned on the icon prior to entering the water. Verify the T-Seal is aligned properly. DO NOT USE SILICONE GREASE as this will damage the seal. To ensure the T-Seal is fully seated in the base of the case, firmly squeeze both sides (the base and lid) of the case together after each insertion of the player. Always check to make sure the latch is closed and locked prior to use. If you have any questions or doubts, please contact H2O Audio Customer Support NOTE: Do not disturb the T-Seal during removal of the player. If the T-Seal is moved, Please use the case lid to completely seat the T-Seal. iN3 - 70 20071106 8. Connecting the Headphones The SealTight Connector is what keeps your audio connection safe and dry underwater. It is designed specifically to create a seal around the H2O Audio Waterproof Headphones (sold separately). Using any other headphones will not have a complete waterproof connection, and reduces the waterproof rating to water-resistant. TM 9. CommanderTM Scroll Wheel Control The Commander Scroll Wheel Control is a waterproof assembly, which allows you to maintain complete control over the iPod's Click wheel functions. Refer to iPod Instruction Manual for complete details of how to use the player. TM 10. [. . . ] Should this product prove to be defective for any reason (other than those listed as limitations below) the product will be serviced or replaced at H2O Audio's sole discretion at no charge (excluding shipping and handling). It may not, in whole or in part, be copied, photocopied, reproduced, translated, or formed into any electronic format without prior consent in writing. H2O Audio is a registered trademark of H2O Audio, Inc. Apple and iPod are registered trademarks of Apple Inc. [. . . ]