User manual HAICOM 3IN1 CAR HOLDER

[. . . ] Copyright Copyright c 2004 All rights reserved This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without the express written consent of the manufacturer. Version 1. 0, March 2004 Trademarks Product names mentioned herein are used for identification purposes only and may be trademarks and/or registered trademarks of their respective companies. [. . . ] Slide cradle up and remove it. 6 Installing the base connector Each brand of PDA requires a different base connector. Consult your local dealer for details on purchasing the correct base connector for your model if needed. Refer to the following to install the base connector: 1. Release the dummy base from the cradle by lifting at tab. Ensure that the connector of the new base is aligned with the socket in the cradle. Insert the base connector until you hear the tab "click" shut. 7 Installing the suction-arm support Caution: Turn off the car's ignition before proceeding. The suction cup must be mounted on a clean, smooth surface, such as the windscreen, or the dashboard. Remove dirt or grease from the surface if necessary. With the locking lever in the up position, place the suction cup on the surface. 8 3. Push the locking lever towards the base to lock the support in place. 4. Insert the power adapter into the socket. 9 Inserting your PDA Editor's Note: Do you need to turn off car ignition to insert PDA?Caution: Turn off the car's ignition before proceeding. When installed in HAICOM 3 in 1 car holder, the battery in your PDA is recharged. Refer to the following to insert your PDA into the cradle: 1. Align the PDA's connector with the connector on the cradle and push down. 2. Press the padded arms firmly against the sides of the PDA to secure it in place. 10 Removing your PDA Refer to the following to remove your PDA from the cradle: 1. [. . . ] Important Safety Notice: Most GPS software has built-in voice navigation to allow you to keep your eyes on the road while driving. If you need to study the map on your PDA, stop the car and pull into the side of the road first. 12 GPS Connector Pin Assignment Ensure the PS2 connector for your GPS receiver conforms to the pin assignments shown below. Color Function CN1 Green White Red Black TX RX VCC GND 5 4 2 1 The connector is a 6-pin Mini-DIN (male) with 3. 6 ± 0. 1 mm wire. IrDA Connection Installation: Setting fi System fi Connect fi Infred (turn OFF) fi OK On test program or map, select com2 and start GPS. 13 14 [. . . ]