User manual HAIER DW12-2

[. . . ] - The carpet must obstruct the opening when the appliance installing on the ground with carpet. - If the supply cord is damaged , it must be replaced by a special cord or assembly available from the manufacturer or its service agent. This appliance complies with the following EEC directives: - 73/23/EEC of 19/02/73(Low Voltage)and subsequent modifications; - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications. - Carefully dispose of the packing material. - After removing the packing, check to make sure that the appliance is not damaged. If in doubt, contact a qualified professional. [. . . ] After the detergent has been placed in the dispenser, close the cover and press down until it clicks in place. C Important: Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs , the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a A lower setting. B C Notice:To facilitate closing the cover, remove any excess detergent on the edges of the dispenser. F C GB . 4. Loading the Dishwasher Before placing the dishes in the dishwasher, remove the large food particle to prevent the filter from becoming clogged, which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need for extra wash cycle. Pull out the rack to facilitate loading the dishwasher. Lower Rack Upper Rack How to Use the Lower Rack We recommend that you place the items which are the most difficult to clean items on the lower rack:pots , lids, serving dishes and bowls, as shown in the figure to the right. It is preferable to place serving dishes and lids on the sides of the racks in order to avoid blocking the rotation of the top spray arm. - Pots, serving bowls, etc. must always be placed top down. - Deep pots should be slanted to allow the water to flow out. - The silverware basket can be doubled(see fig. A) so that only one section may be used when the silver ware load is light. This also makes space for additional pots and pans on the bottom rack. - Silverware should be placed in the silverware basket with the handles at the bottom;if the rack has side baskets, the spoons should be located individually into the appropriate slots. Espe cially long utensils should be placed in the horizontal position at the front of the upper rack. Load for 12 Standard Settings How to Use the Upper Rack The upper rack is designed to hold more delicate and lighter dishware, such as glasses, coffee and tea cups and saucers, as well as plates, small bowls and shallow pans(as long as they are not too dirty). Position the dishes and cookware so that they do not get moved by the spray of water. The upper rack can be adjusted for height. (see fig. B) 1 2 3 4 fig. A fig. B . 5. GB Starting the Appliance Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled, "Loading the Dishwasher"). - Pour in the detergent (see the section entitled, "Salt, Dergent and Rinse Aid"). - Turn the knob located on the right of the control panel in the clockwise direction until the number or symbol for the cycle sec tion entitled, "Wash Cycle Table"). - Press the ON-OFF button, and the ON-OFF light will turn on. At this point, the wash cycle will begin. At the end of the wash cycle When the knob stops turning and is aligned with a STOP mark (see figure), the cycle has finished. Turn off the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher. [. . . ] - Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are. - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater nega tive impact on the enviroment. - There is no untility in rinsing dishes , cookware and untensils before placing them in the dishwasher. How to Keep Your Dishwasher in Shape After Every Wash After every wash, turn off the water supply to the appliance and leave the door slightly ajar so that moisture and odours are not trapped inside. When You Go on Holiday When you go on holiday, it is recommended that you run a wash cycle with the dishwasher empty and then remove the plug from the socket , turn off the water supply and leave the door of the appliance slightly ajar. This will help the seals last longer and prevent odours from forming within the appliance. Remove the Plug Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks. Moving the Appliance If the appliance must be moved, try to keep it in the vertical position. - the water supply to the house on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. The Dishwasher Does Not Start Have you checked whether: - the plug is pushed into the socket correctly; - the power is on in the house; - the door is closed properly; - the ON-OFF switch is on "ON"; - the water supply is turned on. The Dishwasher Does Not Drain Have you checked whether: - the drain hose is crimped or bent. Lime Deposits or a White Film Form on the Dishes Have you checked whether: - the lid to the salt container is closed properly; - the rinse aid dosage is correct. [. . . ]