User manual HAIER GDG 750 AW

[. . . ] Actual model may vary per model purchased. Before beginning installation, carefully read these instructions. this will simplify the installation and ensure the dryer is installed correctly and safely. NOTE: The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/ NFPA 70 or in Canada, CSA C22. [. . . ] D) To check gas inlet pressure, attach 1/8" NPT plugged tapping to dryer gas line shutoff valve. Then connect flare union adapter to plugged tapping. E) Use two adjustable wrenches to tighten every connection. Replacement parts and accessories for US and Canada can be purchased WARNING ADVERTENCIA through Haier America at 1-800-313-8495 cAUTION CAUTION PRECAUCIÓN ATTENTION Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Check PRECAUCIÓN PRECAUCIÓN unit for proper operation after servicing. aDVERTENCIA Discard or destroyADVERTISSMENT plastic bags after the dryer is the carton and ADVERTENCIA unpacked. Children should not be allowed to use them to play with. Cartons covered in rugs, bedspreads or plastic sheets can become an airtight chamber and cause suffocation leading to death. make PRECAUCIÓN ATTENTION all packing materials inaccessible to children. PRECAUCIÓN PRECAUCIÓN ADVERTENCIA The instructions in ADVERTISSMENT all other literature included with this manual and ADVERTENCIA this dryer can not cover every possible condition and situation that may occur. Good safe practice and caution must be applied when installing, operating, and maintaining any appliance. If you are in PRECAUCIÓN ATTENTION doubt after installing, call a certified electrician to install and wire PRECAUCIÓN PRECAUCIÓN the dryer. Press this button once to start the dry process. Press this button once again to pause the activity during the dry cycle. Used to set drying level of auto-programs. This convenient feature helps keep wrinkles from setting when you cannot unload the dryer at the end of a cycle. The dryer will stop and then tumble for a brief period every few minutes. Press the wrinkle saver button to choose the number of hours required, from 3 to 2 4 . Stop the setting at any time by pressing the wrinkle saver button or opening the dryer door. If not set, the wrinkle saver indicator is off and remaining time indicator is on. If setting " W rinkle Saver" in standby status, the LED display indicates 3 hr, which will increase by 1 hr with each press until 2 4 hours is reached It will then return to 3 . [. . . ] All other costs such as labor trip charge, etc are the responsibility of the owner. NOTE: This warranty commences on the date the item was purchased and the original purchase receipt must be presented to the authorized service representative before warranty repairs are rendered. exceptions: Commercial or Rental Use warranty. 90 days labor from date of original purchase. [. . . ]