User manual HAIER H2SM-18CB03R1

[. . . ] For the purpose of safety, the air conditioner must be properly grounded in accordance with specifications. Disposal of the packaging of your new air conditioner All the packaging materials employed in the package of your new air conditioner may be disposed without any danger to the environment. The cardboard box may be broken or cut into smaller pieces and given to a waste paper disposal service. The wrapping bag made of polyethylene and the polyethylene foam pads contain no fluorochloric hydrocarbon. Cautions Always remember to unplug the air conditioner before opening inlet grill. Never unplug your air conditioner by pulling on the power cord. [. . . ] If the button is kept depressed, time will change quickly. After time setting is confirmed, press SET, "AM " and "PM" stop flashing, while clock starts working. Hints After replacing with new batteries, remote controller will conduct self-check, displaying all information on LCD. Then, it will become normal. Operation Auto run, Fan operation (1) Unit start Press ON/OFF button, unit starts. Previous operation status appears on display. (Not Timer setting) AUTO Enjoy yourself by just a gentle press. (2) Select operation mode Press MODE button. For each press, operation AM AUT COOL DR HEA FA SWING TEMP ON Unit will run in selected mode. Stop display at " " AUTO or " " FAN. 4 OFF 1 FAN 3 MODE SLEEP SET (3) FAN Press FAN button. For each press, fan speed changes 2 CLOCK TIMER LOCK RESET LO MED HI AUT AUT Unit will run at selected fan speed. Adjust air flow direction if necessary, referring to page10. (4) Unit stop Press ON/OFF button. Vertical flap closed automatically. Hints Remote controller can memorize settings in each operation mode. To run it next time just select the operation mode and it will start with the previous setting. Operation COOL, HEAT and DRY operation Recommendations: Use COOL in summer. difference of 3-5oC will remove your fatigue. More than this, unit's load can be reduced and power consumption cut down as well. So, you'd Operation TIMER operation Set Clock correctly before starting Timer operation(referring to page 6) You can let unit start or stop automatically at following times: Before you wake up in the TIMER ON/OFF (1)After unit start, select your desire Operation mode will be displayed on LCD. Power indicator on indoor unit lights up. operation mode. (2)TIMER mode selection Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as O N TIMER ON O FF TIMER OFF O N O FF blan TEMP ON SWING OFF AM O N AM TIMER ON-OFF Select your desired TIMER mode (TIMER ON or TIMER OFF) ON or OFF will flash. 1 FAN (3)Timer setting Press HOUR Every time the button is pressed, time increases 10 min. If button is kept depressed, time will change quickly. Every time the button is pressed, time decreases 10 min. If button is kept depressed, time will change quickly. It can be adjusted within 24 hours. MODE CLOCK TIMER SLEEP SET 4 3 2 LOCK RESET (4)Confirming your setting After setting correct time, press SET button to confirm, "ON" or "OFF" stops flashing. Time displayed: Unit starts or stops at x hour x min. Timer mode indicator on indoor unit lights up. To cancel TIMER mode Just press TIMER button several times until TIMER mode Hints After replacing batteries or a power failure happens, Time setting should be reset. [. . . ] During unit operation or at stop, a swishing or gurgling noise may be heard. At first 2-3 minutes after unit start, this noise is more noticeable. (This noise is generated by refrigerant flowing in the system. ) During unit operation, a cracking noise may be heard. This noise is generated by the casing expanding or shrinking because of temperature changes. [. . . ]