User manual HAIER HHX7030 05-05

[. . . ] Before servicing or cleaning the unit, turn the power OFF at the service panel and if possible, lock the service panel to prevent power from being switched on accidentally. When the service panel cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. Do not repair or replace any part of the appliance or attempt any servicing. Note: If for any reason this product requires service, we strongly recommend that a certified technician perform the service. [. . . ] Do not use to exhaust hazardous or explosive materials or vapors. CAUTION To reduce the risk of fire, use only metal ductwork. CAUTION To reduce the risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls or ceilings, or into attics, crawlspaces, or garages. WARNING To reduce the risk of a range top grease fire: a) Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings. b) Always turn the hood ON when cooking at high heat or when cooking flaming foods. Grease should not be allowed to accumulate on fan or filter. Always use cookware appropriate for the size of the surface element. 4 English Installation Preparation To install this range hood, you will need the following tools and materials: Note: This procedure will require 2 people for easier installation. Tools Needed for Installation · · · · · · · · · · · · Drill 1/8" Drill bit for drilling pilot holes 1-1/4" Wood bit for drilling electrical wiring access hole 3/8" Nut Driver or Ratchet with Extension Phillips head screwdriver Flat-head screwdriver Pliers Pencil, rule and level for marking range hood location Hand saw or jig saw for cutting the wall or cabinet openings Duct tape Electrical tape Connector Clamp General Preparation Caution!Please be sure to turn the electrical power switch OFF before beginning the installation. Lay the range hood upside down on a table covered with either cardboard or paper to prevent scratching the hood or table. Remove the 2 grease filters from the hood. Place them somewhere safe so they will not be damaged. Turn the hood right side up so you can see the duct knockouts and mounting holes. 5 English Cabinet Preparation for Hood Support Mount the hood so that the bottom of the hood is between 24"-30" above the stovetop. When cutting or drilling into wall or cabinet, be careful not to cut existing electrical wiring. If the bottom of the cabinet is recessed above the bottom of the cabinet door, then it is necessary to install wood strips on each side of the recessed area on the bottom of the cabinet where the range hood will be mounted. The wood strips should line up with the 4 keyhole slots on the top of the range hood. Fasten the wood strips with wood screws about 3" in from each end. Note: The thickness of the wood strips should be slightly more than the recessed dimension. Measure and mark the electrical wiring opening in the wall or the cabinet. If the hood is to be vented, also mark and measure the duct opening in the wall or cabinet. [. . . ] THIS WARRANTY COVERS UNITS WITHIN THE CONTINENTAL UNITED STATES, CANADA AND PUERTO RICO. THIS WARRANTY DOES NOT COVER: · Damages from improper installation · Damages from shipping · Damages from misuse, abuse, accident, alteration, lack of proper care and maintenance · Damages from service by persons other than an authorized dealer or service center · Labor, service, transportation and shipping charges for the removal of defective parts and for installation of a replacement part, beyond the initial 12-month period. THIS LIMITED WARRANTY IS GIVEN IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. The remedy provided in this warranty is exclusive and is granted in lieu of all other remedies. [. . . ]