User manual HAIER HLP22P 06-03

[. . . ] ® What The World Comes Home To TM POWER START PAUSE WASH PROGRAM RINSE SPIN TEMP WASH/RINSE WATER LEVEL RESERVE ON/OFF Automatic Washing Machine Lave-Linge Automatique Lavarropas Automático User Manual- Model # Manuel d'utilisation- Modèle # Manual de usoModelo # HLP22P English IMPORTANT SAFETY INSTRUCTIONS Warning ­ To reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including the following: 1. Read all instructions before using the appliance. 2. Use this appliance only for its intended purpose as described in this use and care guide. Use only detergents or softeners as recommended for use in this manual and keep them out of the reach of children. [. . . ] Place the panel against the bottom of the machine. Align the holes in the panel with the holes in the washer. Insert the screws through the holes of the panel into the bottom of the washer and tighten. Once all screws have been installed and the panel is in place, return the washer to its standing position. 17 English Leveling the Washer Your washer has 4 leveling legs that are located on the 4 bottom corners. After properly placing your washer in its final location, you may level the washer. · Leveling legs can be adjusted by turning them counter-clockwise to raise the washer and clockwise to lower the washer. Note: If the machine is slanting more than 2° it will not work. Installing Your Washer Read the installation instructions carefully before beginning. Connect the hot and cold water inlet hoses to the hot and cold water faucet. Connect the other ends to their respective washer inlets located at the top rear of the machine. Connect the red tinted hose fitting to the washer and the other end to the incoming water supply. Install the drain hose to the side of the washer using drain hose clamp. The drain hose must be placed into a drainpipe or sink at least 1-1/2 inches in diameter. Use the gooseneck drain hook to hold hose in place. To avoid possible water back up, the drain hose must reach a height of at least 31-1/2 inches minimum and 40 inches maximum. Plug in the Washer to a regular 115 Volt / 60 Hz, 15 Amps outlet. Note: Carefully inspect for any leaks around and back of the machine. If there is a leak, turn off the unit and unplug it, then check if any connections are loose. You may need to tighten any loose connections. CAUTION: If after completing these steps you are still unsure if unit has been properly installed, contact a qualified installer. We recommend that the washer be installed by a certified technician to ensure that it is properly installed. Installing Inner Plate A. Open the top lid of the washing machine. Install the inner plate on the outer tub by aligning the plate shafts to the tub cover groves. [. . . ] For the name and telephone number of the nearest authorized service center please call 1-877-337-3639. Before calling please have available the following information: Model number and serial number of your appliance. The name and address of the dealer you purchased the unit from and the date of purchase. Haier America New York, NY 10018 This warranty covers appliances within the continental United States, Puerto Rico and Canada. [. . . ]