User manual HAIER HMS-1450

[. . . ] Yes No Optional For your safety, any instructions in this manual with this "Warning" sign must be followed strictly. The symbol on the product or on its packing indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, Which could otherwise be caused by inappropriate waste handling of this product. [. . . ] note: Use the hose-set supplied with the appliance. Use the drain hose bracket to keep the end of the drain hose retained and prevent the outflow of water. Fix the drain hose to the clip at the back of the washing machine to prevent it from dropping off. And should be securely fixed and leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less than 80cm, the washing machine will continuously drain while being filled (self-siphoning). Before connecting to the power supply, check: ¬ The socket is adequate for the maximum power of the washing machine (For safety, fuses in the power circuit should be rated for no less than 15A). ⬠The voltage should meet the requirement. ¬ The power outlet should be capable of accepting the washing machine plug. A B C ¬ Program knob ¬ Power Switch ¬ Start/Pause Button _By turning the knob clockwise/counterclockwise, the required program can be selected. After a program is selected, the corresponding light will go on. _ When the washing machine is connected to the power socket and a program is selected, lightly touch this button to start operation. During a wash cycle, touch it lightly , operation will stop and the digits on the screen start blinking. To cancel a wash program during a wash cycle, touch this button, when the digits on the screen start blinking, press the Power switch, the program will be cancelled. _ Touch this button lightly to select the desired speed. When a speed is set, it will be displayed on the screen. Note: Different water temperatures and spinning speeds can be set for different laundries. Wash using the default settings if there is no special requirement. F ¬Delay Button Touch this button lightly, the washing machine will start operation after a period of time and the corresponding indicator will go on. 5-24 hours; each touch of this button increases a half hour. After the button is set, press the Start/Pause button to start countdown of the set time (the time is displayed on the screen until the program ends). Note:The delay time must be longer than the program time;otherwise, the washing machine will start the wash program directly. _Open the drawer, three compartments can be 2 seen: 3 1 Compartment 1: Prewash detergent Compartment 2: Detergent for programs 1 to 8 Compartment 3: Softener, conditioning agent, perfume, etc. [. . . ] Do not use dry cleaning agents such as trichloroethylene and similar products. Note: Do not add more detergent than needed. Slide out the detergent drawer and put the required detergent and softening agent into the corresponding compartments. (Refer to the instructions on the drawer) Caution: ¬ For prewashing program, detergent should be added to both compartments 1 and 2. [. . . ]