User manual HAIER HR 165

[. . . ] *Do not obstruct or cover the ventilation grille of the appliance. *Do not allow children to play with the appliance. In no case should children be allowed to sit on the drawers or hang onto the door. *Warning: Keep ventilation openings in the appliance enclosure or in the structure for building in , clear of obstruction. [. . . ] Run the mains cable through the unit such that it can be connected to the power supply after installing the appliance. Remove the cover (6) only if space is restricted. Push the appliance into the kitchen unit leaving a gap of 4mm at the handle side of the appliance. Align the top and bottom front edges of the support brackets (2) such that they are flush with the front edge of the kitchen unit. Cut sealing strip (1) to the height of the kitchen unit and attach to the handle side of the unit to close the gap between the appliance and the side panel of the kitchen unit (press the strip (a) into the gap. Pull away the protective strip on the plastic profile before insertion. Push the appliance against the side panel of the kitchen unit and secure it at the top and bottom (3). Install the door connecting element (4) in accordance with the handle height and the number of doors. Open the door fully and insert the connecting rod (5) and screw it to the kitchen unit door maintaining distance (d) to the edge of the door (d=the thickness of the panel). Adjust the connecting element so that the handle side of the kitchen unit door does not make contact with the unit body when closed. (Approximately 1mm gap for large appliances), mount the second door connecting element where appropriate. *Level the kitchen cabinet unit with a spirit level and a try square. Level the unit by placing packing material underneath if required. *A minimum gap of 38mm must be maintained at the back of the appliance for ventilation. *Air inlet A must be at least 200 cm square and air must flow through the panel in the cabinet plinth. *Check that the position of the power socket (1) is correct. AC voltage in the location at which the appliance is to be used must comply with that as shown on the data plate located on the left inside wall of the appliance next to the vegetable bins. The power supply must be suitably earthed. After connecting to the power supply, turn the temperature controller clockwise from position 0 to any position between 1 and 7 to start the refrigerator. Cold storage is for short-term food storage or for daily consumption. Although the temperature in most parts of the cold storage compartment can be regulated between 0 and 10 degrees Centigrade, extended periods of food storage is not recommended. Cold storage should only be used for short-term storage. [. . . ] * Remove the door of the refrigerator when you get rid of it, in case children may get trapped in. If the power failure lasts for an extended period, unplug the refrigerator and clean the refrigerator as previously described. Keep the door of refrigerator open when the power is turned off to prevent any food remaining in the compartment from producing bad odors. * Unplug the refrigerator * Remove any food * Tigh0ten the shelf and vegetable tray with tapes * Tightly close the door with tape Caution: It is recommended that the refrigerator is not turned off * The temperature of the refrigerator and the compressor will rise and the compressor will run for comparatively longer periods when the refrigerator is first started. [. . . ]