User manual HAIER HSU-07CW03R1

[. . . ] Damaged air conditioners are not to be put into operation. In case of doubt, consult your supplier. Use of the air conditioner is to be carried out in strict compliance with the relative instructions set forth in the User's Guide. Installation shall be done by professional people, don't install unit by yourself. [. . . ] Vertical flap closed automatically. Hints Remote controller can memorize settings in each operation mode. To run it next time just select the operation mode and it will start with the previous setting. Operation COOL, HEAT and DRY operation Recommendations: Use COOL in summer. Use DRY in spring, autumn and in damp climate. (1) Unit start Press ON/OFF button, unit starts. Previous operation status appears on display. (Not Timer setting) Power indicator on indoor unit lights up. AUTO (2) Select operation mode Press MODE button. For each press, operation AM TEMP 3 1 FAN AUT COOL DR HEA FA ON 5 SWING 6 OFF 4 Unit will run in operation mode displayed on LCD. MODE SLEEP SET 2 CLOCK TIMER LOCK RESET (3) Select temp. setting Press TEMP. button Every time the button is pressed, temp. setting increases 1oC Every time the button is pressed, temp. setting decreases 1oC Unit will start running to reach the temp. setting on (4) Fan speed selection Press FAN button. For each press, fan speed changes LO MED HI AUT AUT Unit runs at the speed displayed on LCD. In HEAT mode, warm air will blow out after a short period of time due to cold-draft prevention function. setting, unit will run intermittently at LO speed regardless of FAN setting. COOL operation starts when room temp. setting, unit will run in mild DRY mode. Hints Remote controller can memorize each operation status. When starting it next time, just press ON/OFF button and unit will run in previous status. On cooling only unit, heating mode is not available. Operation (5) Air flow direction adjustment After operation mode is selected, vertical flap will open automatically according to the mode. Referring to the Fig. COOL About 10o HEAT About 60o Up and down (Use remote controller) Left and right air flow adjustment Press SWING button, vertical flap will move within (manual) the range shown in the Fig. Press SWING button stop it at a fixed position. Move the horizontal blade by a knob on air conditioner to adjust left and right direction About 10o COOL About 45o HEAT About 60o Cautions: It is advisable not to keep vertical flap at downward position for a long time in COOL or DRY mode, otherwise, condensate Cautions: When humidity is high, condensate water might occur at air outlet if all horizontal louvers are adjusted to left or right. (6) Unit stop Press ON/OFF button. Vertical flap closes automatically. Cautions: Unit won't restart until 3 minutes have elapsed, due to system protection. HEAT mode is not available on cooling only unit. Hints As cold air flows downward in COOL mode, adjusting air flow horizontally will be much more helpful for a better air circulation. As warm air flows upward in HEAT mode, adjusting air flow downward will be much more helpful for a better air circulation. [. . . ] Should there be a big noise from air flow in unit operation, air filter may be too dirty. This is because the system circulates smells from the interior air such as the smell of furniture, cigarettes. During COOL or DRY operation, indoor unit may blow out mist. This is due to the sudden cooling of indoor air. Noise is heard. Normal Performanc e Smells are Mist or steam are blown Does not work at all. [. . . ]