User manual HAIER HSU-10HB03(B)

[. . . ] Never unplug your air conditioner by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet. All electrical repairs must be carried out by qualified electricians. Inadequate repairs may result in a major source of danger for the user of the air conditioner. Do not damage any parts of the air All these valuable materials may be taken to conditioner that carry refrigerant by piercing a waste collecting center and used again after or performating the air conditioner's tubes adequate recycling. [. . . ] If the fuse of indoor unit on PC board is broken, please change it with the type of T. The wiring method should be in line with the local wiring standard. After installation, the power plug should be easily reached. The waste battery should be disposed properly. 2 Cautions Safety Instruction Please read the following Safety Instructions carefully prior to use. The instructions are classified into two levels, WARNING and CAUTION according to the seriousness of possible risks and damages as follows. Compliance to the instructions are strictly required for safety use. Installation WARNING Please call Sales/Service Shop for the Installation. Do not attempt to install the air conditioner by yourself because improper works may cause electric shock, fire, water leakage. lnstallation in a inadequate place may cause accidents. Do not install in the following place. Connect the earth cable. Do not install in the Do not get the unit place where there is exposed to vapor any possibility of or oil steam. inflammable gas leakage around the unit. Check proper installation of the drainage securely earthing PROHIBITION PROHIBITION STRICT ENFORCEMENT 3 Cautions WARNING When abnormality such as burnt-small found, immediately stop the operation button and contact sales shop. Use an exclusive power source with a circuit breaker STRICT ENFORCEMENT Use the proper voltage Do not use power supply cord extended or connected in halfway OFF Connect power supply cord to the outlet completely STRICT ENFORCEMENT Do not use power supply cord in a bundle. STRICT ENFORCEMENT Take care not to damage the power supply cord. PROHIBITION Do not insert objects into the air inlet or outlet. PROHIBITION Do not start or stop the operation by disconnecting the power supply cord and so on. PROHIBITION Do not channel the air flow directly at people, especially at infants or the aged. PROHIBITION Do not try to repair or reconstruct by yourself. PROHIBITION PROHIBITION CAUTION Do not use for the purpose of storage of Take fresh air occasionally especially Do not operate the switch with food, art work, precise equipment, when gas appliance is running at the wet hand. same time. PROHIBITION Do not install the unit near a fireplace or other heating apparatus. STRICT ENFORCEMENT Check good condition of the installation stand PROHIBITION Do not pour water onto the unit for cleaning PROHIBITION Do not place animals or plants in the direct path of the air flow PROHIBITION Do not place any objects on or climb on the unit. PROHIBITION Do not place flower vase or water containers on the top of the unit. PROHIBITION PROHIBITION PROHIBITION 4 Parts and Functions Indoor unit Display board Inlet Air Purifying Filter (inside) Inlet grille Vertical flap (adjust up and down air flow. FRESH button Used to set FRESH AIR operation. 31 NOTE: (1)The following functions and related displays are not available , , and (2) Cooling only unit do not have functions and displays related with heating. . 6 Parts and Functions Clock Set When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows: 1. Press CLOCK button, "AM" or "PM" flashes. TIMER MODE HEALTH AIRFLOW SLEEP HEALTH FRESH CLOCK SET STERILIZE 2. Each press will increase or decrease 1 min. If the button is kept depressed, time will change quickly. RESET CODE LIGHT LOCK 3. After time setting is confirmed, press SET, "AM" or "PM" stop flashing, while clock starts working. Remote controller's operation When in use, put the signal transmission head directly to the receiver hole on the indoor unit. The distance between the signal transmission head and the receiver hole should be within 7 m without any obstacle as well. Don't throw or knock the remoter controller. When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturbed in receiving the signals, so the distance to the indoor unit should be shorter. Loading of the battery Load the batteries as illustrated right 2 R-03 (7#) batteries Remove the battery cover: Slightly press" "area and push down the cover as illustrated. Load the battery: Be sure that the loading is in line with the "+" / ". request as illustrated on the bottom of the case. [. . . ] For each press, is displayed. Air conditioner starts health anion function operation. For twice press, disappears, the operation stops. AM TEMP SWING ON OFF FAN 3. UV light degerming function Press STERILIZE button , " "and " "displayed on the remote controller and the air conditioning starts the UV light degerming function. " ": For timing operation of UV light degerming function and automatically canceled after 30 minutes' operation. " ": For the long-time running of UV light degerming function. [. . . ]