User manual HAIER HSU-12H03

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HAIER HSU-12H03. We hope that this HAIER HSU-12H03 user guide will be useful to you.

Lastmanuals help download the user guide HAIER HSU-12H03.


Mode d'emploi HAIER HSU-12H03
Download
Manual abstract: user guide HAIER HSU-12H03

Detailed instructions for use are in the User's Guide.

[. . . ] The waste battery should be disposed properly. The appliance is not intended to use by young children or infirm persons without supervision. 9. Young children should be supervised ensure that they do not play with the appliance. 10. The appliance must be installed on strong enough supporter. [. . . ] setting, unit will run intermittently at LO speed regardless of FAN setting. o Hints On cooling only unit, heating mode is not available. Remote controller can memorize each operation status. When starting it next time, just press ON/OFF button and unit will run in previous status. 5 Operation (5) Air flow direction adjustment After operation mode is selected, vertical flap will open automatically according to the mode. COOL About 10 o HEAT About 60o Up and down (Use remote controller) Left and right air flow adjustment Press SWING button, vertical flap will move within (manual) the range shown in the Fig. Press SWING button stop it at a fixed position. Vertical flap will resume original position one hour later in order to avoid condensate water. About 10o COOL About 45o HEAT About 60o Move the horizontal blade by a knob on air conditioner to adjust left and right direction referring to Fig. Cautions: It is advisable not to keep vertical flap at downward position for a long time in COOL or DRY mode, otherwise, condensate water might occur. Cautions: When humidity is high, condensate water might occur at air outlet if all horizontal louvers are adjusted to left or right. (6) Unit stop Press ON/OFF button. Vertical flap closes automatically. Cautions: Unit won't restart until 3 minutes have elapsed, due to system protection. HEAT mode is not available on cooling only unit. Hints As cold air flows downward in COOL mode, adjusting air flow horizontally will be much more helpful for a better air circulation. As warm air flows upward in HEAT mode, adjusting air flow downward will be much more helpful for a better air circulation. Be careful not to catch a cold when cold air blows downward. It is harmful to your health in summer to go frequently in and out of places where temp. difference of 3-5 C will remove your fatigue. More than this, unit's load can be reduced and power consumption cut down as well. difference of 3-5 C between indoor and outdoor temp. in COOL mode. 6 Operation POWER/SOFT Operation POWER Operation When you need rapid heating or cooling, you can use this funciton. ON/OFF TEMP Selecting of POWER operation Press POWER/SOFT button. Every time the button is pressed, display changes as follows: BLANK POWER SOFT MODE SET FAN TIMER Stop the display at SWING CLOCK In POWER operation status: In COOL mode, when room temperature is lower 4 C than temperature setting , compressor runs high-frequency for 15 min then returns to original status setting. In HEAT mode, when room temperature is higher 6 C than temperature setting , compressor runs high-frequency for 15 min then returns to original status setting. o o LOCK POWER/SOFT RESET To cancel POWER operation Press POWER/SOFT button twice , POWER/SOFT disappears. SOFT Operation You can use this function when silence is needed for rest or reading. Selecting of SOFT operation Press POWER/SOFT button. Every time the button is pressed, display changes as follows: BLANK POWER SOFT Stop the display at In SOFT operation mode, fan speed automatically takes"LOW" To cancel POWER operation Press POWER/SOFT button once , POWER/SOFT disappears. Hints: During POWER operation, in rapid HEAT or COOL mode, the room will show inhomogeneous temperature distribution. Long period SOFT operation will cause effect of not too cool or not too warm. 7 Operation TIMER Operation Set Clock correctly before starting Timer operation You can let unit start or stop automatically at following times: Before you wake up in the morning, or get back from outside or after you fall asleep at night. TIMER ON/OFF (1)After unit start, select your desired operation mode. Operation mode will be displayed on LCD. [. . . ] During COOL or DRY operation, indoor unit may blow out mist. This is due to the sudden cooling of indoor air. Is fuse blown out? Is the air filter dirty?Normally it should be cleaned every 15 days. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE HAIER HSU-12H03

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HAIER HSU-12H03 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag