User manual HAIER HSU-12HH03(B)

[. . . ] Please ensure that the pipework of your air conditioner does not get damagedprior to being picked up by the relevant waste disposal center, and contribute to environmental awareness by insisting on an appropriate, anti-pollution method of disposal. Safety Instructions and Warnings Before starting the air conditioner, read the information given in the User's Guide carefully. The User's Guide contains very important observations relating to the assembly, operation and maintenance of the air conditioner. The manufacturer does not accept responsibility for any damages that may arise due to non-observation of the following instruction. Damaged air conditioners are not to be put into operation. [. . . ] NOTE: Cooling only unit do not have displays and functions related with heating The unit do not have functions related with healthing. Hints After replacing with new batteries, remote controller will conduct self-check, displaying all information on LCD. Then, it will become normal. 4 Operation Remote controller's operation When in use, put the signal transmission head directly to the receiver hole on the indoor unit. The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well. Don't throw the controller, prevent it from being damaged. When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturbed in receivering the signals so the distance to the indoor unit should be shorter. Loading of the battery Load the batteries as illustrated. 2 R-03 batteries, resetting key (cylinder) Remove the battery cover: Slightly press " " and push down the cover. , ͬ ȡ ѡ , ʱ 7# , ҹ © , 6 ԡ ء ˾ װ ѡͬһƷ 7# , ʱ䲻ʱ, Ϊ ֹ©ҹ뽫ȡ ʹ쳣, ȡ, 6Ӻ װµء ൺ յܹ˾ ѡͬһƷ 7# , ʱ䲻ʱ, Ϊ ֹ©ҹ뽫ȡ ʹ쳣, ȡ, 6Ӻ װµء ൺ յܹ˾ Load the battery: Be sure that the loading is in line with the" + "/"-" pole request as illustrated. Put on the cover again Confirmation indicator: In disorderation, reload the batteries or load the new batteries after 6mins. Note: Use two new same-typed batteries when loading. If the remote controller can't run normally or doesn't work at all, use a sharp pointed item to press the reset key. Hint: Remove the batteries in case unit won't be in usage for a long period. If there are any display after taking-out just need to press reset key. 5 Operation Cool Operation (1) Unit start Press ON/OFF button, unit starts. Previous operation status appears on display. (Not Timer setting) (2) Select operation mode Press MODE button. For each press, operation mode changes as follows: COOL DRY HEAT ON/OFF TEMP 1 4MODE 2 FAN SET Unit will run in operation mode displayed on LCD. o Every time the button is pressed, temp. setting increases 1 C o Every time the button is pressed, temp. setting decreases 1 C Unit will start running to reach the temp. setting on LCD. 2 FAN TIMER 4 SWING CLOCK 5 (4) Fan speed selection Press FAN button. For each press, fan speed changes as follows: LOCK HEALTH POWER/SOFT RESET AUTO HI MED LO COOL operation starts when room temp. Ultra-low air flow Unit runs at the speed displayed on LCD. In DRY mode, when room temperature becomes lower than temp. setting+2oC, unit will run intermittently at LOW speed regardless of FAN setting. Temp. setting, unit will run in mild DRY mode. Remote controller can memorize each operation status. When starting it next time, just press ON/OFF button and unit will run in previous status. Hints 8 Operation (5) Air flow direction adjustment After operation mode is selected, horizontal flap will open automatically according to the mode. COOL About 10o Up and down (Use remote controller) Press SWING button, horizontal flap will move within the range shown in the Fig. Press SWING button stop it at a fixed position. Move the vertical blade by a knob on air conditioner to adjust left and right direction referring to Fig. Left and right air flow adjustment (manual) About 10o COOL About 45o Cautions: It is advisable not to keep horizontal flap at downward position for a long time in COOL or DRY mode, otherwise, condensate water might occur. Cautions: When humidity is high, condensate water might occur at air outlet if all vertical louvers are adjusted to left or right. (6) Unit stop Press ON/OFF button. [. . . ] In normal family, it will be solarized every 6 months. The bacteria-killing medium air purifying filter will be used for a long time, no need for replacement. But in the period of using them , you should remove the dust frequently by using vacuum cleaner or flaping them lightly, otherwise , its performance will be affected. Please keep the bacteria-killing medium air purifying filter in the cool and dry conditions avoid long time directly sunshine when you stop using it, or its ability of sterilization will be reduced. 13 Maintenance For Smart Use of The Air Conditioner Setting of proper room temperature Proper temperature Do not block the air inlet or outlet Close doors and windows Use the timer effectively during operation During cooling operation prevent the penetration of direct sunlight with curtain or blind If the unit is not to be used Use the louvers effectively for a long time, turn off the power supply main switch. OFF 14 Cautions Safety Instruction Please read the following Safety Instructions carefully prior to use. [. . . ]