User manual HAIER HSU-12LEA13-H

[. . . ] TEMP Used to select your desired temperature. POWER ON/OFF Used for unit start or stop 24. SLEEP Used to select sleep mode AUTO NOTE:(1)The following functions and related displays are not available :HEALTH display, AUXILIARY HEAT display, POWER/SOFT display. (2)If the Air condition don't have the function, press code B can cause it not available. (3)Cool only unit do not have functions and displays related with heating. Clock set When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows: Press CLOCK button, "AM" or "PM" flashes. [. . . ] For each press, operation mode changes as follows: AUTO COOL DRY FAN SWING TEMP ON 3 FAN Unit will run in operation mode displayed on LCD. Stop display at your desired mode. 1 OFF 5 6 MODE 4 SLEEP (3) Select temp. setting increases 1oC Every time the button is pressed, temp. setting decreases 1oC Unit will start running to reach the temp. setting on LCD. 2 CLOCK SET TIMER (4) Fan speed selection Press FAN button. For each press, fan speed changes as follows: RESET CODE LOCK AUTO AUTO LO MED HI COOL operation starts when room temp. setting. Ultra-low air flow Unit runs at the speed displayed on LCD. setting, unit will run intermittently at LO speed regardless of FAN setting. Temp. setting, unit will run in mild DRY mode. Hints Remote controller can memorize each operation status. When starting it next time, just press ON/OFF button and unit will run in previous status. 8 Operation (5) Air flow direction adjustment After operation mode is selected, vertical flap will open automatically according to the mode. COOL About 10o Level Up and down (Use remote controller) Press SWING button, vertical flap will move within the range shown in the Fig. Every time the button is pressed, time decreases 10min. If button is kept depressed, time will change quickly. AM refer's to morning and PM to afternoon. SWING TEMP ON OFF 1 SLEEP FAN MODE CLOCK 3 SET TIMER 6 4 5 LOCK 2 RESET CODE (4) Time confirming for TIMER ON After time setting, press TIMER button to confirm. "ON" stops blinking, While "OFF" starts blinking. Time displayed: Unit starts at x hour x min. (5)Time setting for TIMER OFF After time setting, press SET button to confirm, "OFF" stops flashing. Time displayed: Unit stops at X hour X min. (6) Time confirming for TIMER OFF Follow the same procedures in "Time setting for TIMER ON". To cancel TIMER mode Just press TIMER button several times until TIMER mode disappears. 11 Operation Comfortable SLEEP Before going to bed at night, you can simply press the SLEEP button and unit will bring you a sound sleep in selected mode. TEMP A ON OFF SWING FAN MODE SLEEP CLOCK SET TIMER RESET CODE LOCK In COOL , DRY mode One hour after SLEEP mode starts, temp. Unit will run for 6 hours then stops automatically. won't be too low for your sleep. (As shown in Fig. 1) SLEEP operation starts SLEEP operation stops Approx. 6 hrs 1 hr Rises 1oC 1 hr Rises 1oC Note: In AUTO mode, unit will run in SLEEP function according to operation mode. In FAN mode, comfortable sleep is not available. Temp. setting Unit stop Fig. 1 12 Operation Emergency operation and test operation Emergency Operation: Carry out this operation only when the remote controller is defective or lost. [. . . ] During unit operation or at stop, a swishing or gurgling noise may be heard. At first 2-3 minutes after unit start, this noise is more noticeable. (This noise is generated by refrigerant flowing in the system. ) During unit operation, a cracking noise may be heard. This noise is generated by the casing expanding or shrinking because of temperature changes. [. . . ]