User manual HAIER HSU-18C03R1

[. . . ] If the fuse on PC board is broken please change it with the type of T. The distance between the indoor unit and the floor should be more than 2m. The wiring method should be in line with the local wiring standard. After installation, the power plug should be easily reached. [. . . ] FAN ON/OFF TEMP 1 4MODE 2 FAN SET TIMER Unit will run in selected mode. Stop display at " " AUTO or " 3 SWING CLOCK (3) FAN Press FAN button. For each press, fan speed changes as follows: SLEEP HEALTH LOCK RESET AUTO LO MED HI Unit will run at selected fan speed. Note:AUTO is not available in FAN mode. (4) Unit stop Press ON/OFF button. Vertical flap closed automatically. Remote controller can memorize settings in each operation mode. To run it next time just select the operation mode and it will start with the previous setting. No reelecting is needed. (TIMER ON/OFF needs reelecting) Cautions: Note: On cooling only unit, heating mode is not available, The above information is the After replacing batteries, press ON/OFF, and display explanation of the displayed becomes as follows: information therefore varies Operation mode: AUTO, Temp. No with those displayed in actual Timer mode: No, Fan speed :AUTO operation. Hints 7 Operation COOL, HEAT and DRY operation Recommendations: (1) Unit start Use COOL in summer. Use HEAT in winter Use DRY in spring, autumn and in damp climate. Press ON/OFF button, unit starts. Previous operation status appears on display. (Not Timer setting) Power indicator on indoor unit lights up. (2) Select operation mode Press MODE button. in COOL mode. 9 Operation TIMER Operation Set Clock correctly before starting Timer operation You can let unit start or stop automatically at following times: Before you wake up in the morning, or get back from outside or after you fall asleep at night. TIMER ON/OFF (1)After unit start, select your desired operation mode. Operation mode will be displayed on LCD. Power indicator on indoor unit lights up. (2)TIMER mode selection ON TIMER ON Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: OFF TIMER OFF ON o C AM ON OFF blank TIMER ON-OFF ON/OFF TEMP Select your desired TIMER mode (TIMER ON or TIMER OFF) ON or OFF will flash. MODE 1 3 3 SET (3)Timer setting Press HOUR / button. Every time the button is pressed, time increases 10 min. If button is kept depressed, time will change quickly. Every time the button is pressed, time decreases 10 min. If button is kept depressed, time will change quickly. It can be adjusted within 24 hours. FAN TIMER 4 SWING 2 CLOCK SLEEP HEALTH LOCK RESET (4)Confirming your setting After setting correct time, press SET button to confirm, "ON" or "OFF" stops flashing Time displayed: Unit starts or stops at x hour x min. Timer mode indicator on indoor unit lights up. To cancel TIMER mode Just press TIMER button several times until TIMER mode disappears. Hints After replacing batteries or a power failure happens, Time setting should be reset. Remote controller possesses memory function, when use TIMER mode next time, just press SET button after mode selecting if timer setting is the same as previous one. 10 Operation TIMER ON-OFF (1)After unit start, select your desired operation mode Operation mode will be displayed on LCD. [. . . ] 3 hrs 3 hrs SLEEP mode starts Rises 1oC SLEEP mode stops Unit stop Note: In AUTO mode, unit will run in SLEEP function according to operation mode. In FAN mode, comfortable sleep is not available. Fig. 2 14 Maintenance Different models have different appearance Cleaning of unit casing Cut off power supply before cleaning unit casing with soft cloth. In case of heavy stain, clean it with neutral detergent. squeeze water in the cloth, wipe off the detergent on unit casing completely. Cleaning of remote controller Cleaning of air filter Don't use water to wash unit casing, please use dry cloth. [. . . ]