User manual HAIER HVC24CB

[. . . ] 6) If your old wine cellar is not being used, we recommend that you remove the door and leave the shelves in place. This will reduce the possibility of danger to children. 7) Do not operate your wine cellar in the presence of explosive fumes. 8) Do not store foods in wine cellar as interior temperature may not be cool enough to prevent spoilage. 1 English SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE DANGER Risk of child entrapment. [. . . ] · Select a suitable location for the wine cellar on a hard even surface away from direct sunlight or heat source e. g. radiators, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with the leveling legs located on the front and rear bottom corners of the wine cellar. DIMENSIONS · Built-in wine cellars need to be ventilated from the front. This feature allows the unit to be built in an enclosed area. The bottom front grille should be clear of all obstructions. This is absolutely necessary for the air to circulate and for the unit to operate efficiently. The dimensions for installation are as follows. (W x D x H) Unit Dimensions: 23-7/8" x 23-15/16" x 34-1/4" Built-In Dimensions: 24" x 24" x 35" 34-11/16" 34-1/4" 23-15/16" 23-3/4" 23-7/8" CHOICES · As the doors of the built-in wine cellars are reversible, 2 wine cellars could be placed side by side with the doors opening from the middle. This would not only allow you more storage space but also better placement of your wine collection. The red wines could be separate from the white wines. Before installing make sure there is enough space for installation and that both the units are plugged into separate power receptacles. 7 English DOOR REVERSAL Upper hinge cover Upper hinge bracket Bottom hinge bracket Door Stopper 1. Remove the upper hinge cover and then using a Phillips screw driver remove the upper hinge bracket by removing the 4 screws on the bracket. Remove the bottom hinge bracket by removing the 3 hexagonal nuts. Be careful not to loose the door level rings which are placed in the hinge bracket axle. Remove the door support bracket from the opposite side (left side), by removing the 2 screws. Remove the lower door stopper as shown in the figure and install on opposite side of door. To install the bottom hinge bracket on the opposite side (left side), you will also have to remove one screw hole plug from the left side. Install the door support bracket on the opposite side (right side), place the screw hole plug in the bottom hole. Carefully align the bottom hinge axle hole on the door with the axle of the lower hinge bracket. Remember to have the door level rings in place before you place the door on its axle. Install the upper hinge bracket (left side hinge bracket supplied as an accessory) on the left side. [. . . ] Labor (after the initial 12 months). | THIS LIMITED WARRANTY IS GIVEN IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE The remedy provided in this warranty is exclusive and is granted in lieu of all other remedies. This warranty does not cover incidental or consequential damages, so the above limitations may not apply to you. Some States do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. This warranty gives you specific legal rights, and you may have other rights, which vary, from state to state. [. . . ]