User manual HAIER HW-18C03/R1

[. . . ] setting Auto swing Mode selection Operation panel WAIT 3 MINUTES BEFORE RESTARTING Air inlet (indoor side) Cabinet Operation panel Ventilation lever Auto swing switch Thermostat switch Mode selection switch 3 Operation Guide Auto air deflector switch When the switch is set to " ", the indicator lights up, and vertical louvers will swing from side to side, delivering gentle air thus making you feel very comfortable. When it is set to " ", the indicator goes out, and the vertical louvers stop at any position. Auto swing Mode selection switch Mode selection switch controls the fan motor speed and cooling speed. Mode selection <1> When set to " <2> When set to " ", fan motor runs at high speed to blow out strong air. ", fan motor runs at low speed to blow out gentle air. ", air conditioner will start cooling at low speed, blowing out gentle air. [. . . ] (2) Push the part marked " PUSH " until you hear a click. CAUTION Power cord: Only to use an exclusive power cord. Changing installation site: If the air conditioner needs to be changed to another location, please contact the dealer that sold you the unit. 6 Cautions Avoid opening doors and windows as much as possible. Keep heat sources away from the air conditioner. Keep away from me Use curtain or blinds. Direct sunlight may reduce cooling effect, so always use window curtain. Before operating the mode selection switch, check whether the air inlet or outlet has been blocked. No entrance Do not hang clothes in the vicinity of the air inlet. This will decrease the cooling effect and cause abnormal operation. Go away! For longer and trouble-free operation of the unit, pay special attention to the following: Install the air conditioner at a location strong enough to support the unit. Leave enough space around the air inlet and outlet for better circulation. Problems may occur if the unit is installed in the following areas: Place where oil exists in the air including engine oil, seaside with salt breeze, and hot springs area with air-borne sulfurous gas. 7 Troubleshooting Condition Check Item Is plug firmly inserted?Is there power failure? Corrective Action Restore power or replace fuse. Doesn't operate Is thermostat switch incorrectly adjusted? Adjust the thermostat. Is there direct sunlight into the room?Is mode selection switch set to fan mode?Is there any obstacle blocking air inlet or outlet? Use curtain or blinds. No cool air or poor cooling Shut doors and windows. Remove the obstacle. Is the fresh air knob shifted to the right?Is there a strong heat source in the room?Is air filter clogged? Close vent by shifting knob to the left. Remove and clean. If problems cannot be solved, please pull out power plug and contact your dealer. 8 Installation Instructions Selection of the installation position 1. Select position where the structure is firm. Select position where the air inlet and outlet are not blocked by obstacles. Select position where the cooled air can be blown to every corner of the room. Select position where there's no direct sunlight. If sunlight cannot be avoided, some means of sun shade is required. Select position where the outdoor airflow will not bother neighbors. [. . . ] (Fig. 1) A Metal support Model HW-18C03/R1 A 440mm B 670mm B Fig. 1 Thickness of wall Condenser 2. Attach a metal support (not provided by manufacturer) in a firm location with expanding screws or bolts. Remove the air conditioner from its packing carton. Place the air conditioner on the metal support. [. . . ]