User manual HAIER HW-18EM13

[. . . ] ROOM AIR CONDITIONER HW-18EM13(T3) HW-24EM13(T3) This function will work only under cooling status. 0010532244 LOW COOL OFF FAN LOW HEAT MED COOL HIGH COOL HIGH HEAT MED COOL LOW COOL HIGH COOL OFF FAN LOW HEAT HIGH HEAT Mode switch controls the fan motor speed, Cooling speed or Heating speed. When set to "FAN", fan motor runs to blow out air. [. . . ] 3. The shutters at both sides and the top of air-conditioner should be protruded outdoors free from being blocked by wall, window, ect. 4. The back of air-conditioner should be kept over 500mm from the obstacles (for example, wall, etc. ) (As illustrated in Fig. 5. To have an efficient drainage, the back part of the air-conditioner should be inclined downward by 5-10mm (As illustrated in Fig. Fix the prefabricated iron frame to stable position by expansible screws. Put the whole machine with all the accessories installed, on the iron frame. If there's water outlet flexible pipe, lead it to needed position(see Fig. 1). cover Wall support fig. 1 Water outlet flexible pipe(provide by user) Fig. 1 3. Fill any distance between the wall hole and the machine body with flexible sponge rubber strip to prevent the entering of outer noise and the leaking of the coolness. After installation of the conditioner, insert the power plug into the outlet and perform test-run. >500mm 5-10mm fig. 2 fig. 3 Cautions NOTES: For longer and trouble-free operation of the unit, pay special attention to the following: Install air-con at a place strong enough to support the unit. Leave enough space around air inlet and outlet for better circulation. Problems may occur if unit is installed in the following places: Place where oil exists in the air including engine oil or seaside with salt breeze blows and hot spring area with sulphurous gas in the air. Power cord: Be sure to use the exclusive power cord. Change installation place: If air-con need to be changed to another place please contact the dealer, who sold you the unit. Always use at the rated voltage and with specfic air conditioning circuit THE ENCLOSED ACCESSORIES OF THE CONDITIONER Name Rubber lid Outlet pipe fitting Manual Sealed gasket Figure 5 TROUBLESHOOTING HW-18EM13(T3) HW-24EM13(T3) 1 1 1 1 Before calling for service. PREPARATIONS BEFORE INSTALLATION Make the wall hole or window hole (see Fig. 1) 57 68 Phenomenon Check the following points before calling for repairs or service. Cause or check points Solution MODEL A B A Iron frame Switch on the machine but it does not work immediately. If the machine is started after stop, it will need about 3 minutes to re-start so as to prevent the fuse from break. HW-18EM13(T3) HW-24EM13(T3) 440mm 635mm B Width of the wall Fig. 1 Prepare unit for installation: 1. Take out the conditioner and accessories from the package . [. . . ] (See Fig. 2) Fig. 2 Rubber lid Are there any obstacles blocking air inlet and outlet? Remove the obstacles. Clean it. Is air filter clogged? Outlet pipe fitting Bottom plate hole If necessary the above two methods can both have extra pipe added on the outlet pipe fitting (available on the market). Is there too much heat source in the room? Remove the heat source NOTE:For some model the air conditioner is designed to splash the condensed water on the heat exchanger for maximun cooling efficiency, the extra condensed water will be blown out from the machine , But the hitting noise by the fan at the outdoor side is relatively. (See Fig. 3) Fig. 3 If problems can not be solved please pull out power plug and contact your dealer. Bottom plate [. . . ]