User manual HAIER HW-24LN13

[. . . ] 5. TEMP. or TIME set Used to set TIME or TEMP. setting. 6. E-S ENERGY SAVER 7. SWING Used to activate the vertical louver . This will give you an even airflow througout the room. 8. ENERGY SAVER 9. TEMP. /TIME display CAUTION To protect unit system, don't restart until 3 minutes have elapsed. [. . . ] When the compressor turns back on, the fan will turn on at the same time. In the "Off" position , the fan will not shut off when the compressor cycles off. Timer operation With this function, unit will start or stop at the time you want. 1. Start unit and select desired operation mode. 2. Select Timer function Timer On or Off stop mode is used to preset or shut off your unit in advance . You can program this up to 24 hours in advance. You can use the Timer in 3 function i. e Cool Dehumid or Fan only. (TIMER On or Off stop ) Timer On Unit must be on to set the timer. Unit will shut down automatically after it accepts the setting in 5 seconds. Use this mode to preset the start time of the unit 24 hours in advance . a) Press "On" of remote controller or "TIMER" of control panel, LED display will show "01". (Electrify for the first time) b) Set desired number by pressing the ( )pad of the Temp/Time buttons. If you passed the desired time use the ( ) pad key to lower the selection. Timer Off Unit must be running to set the timer off. Use this to preset the time you would like the unit to shut off. a) Press "off" of remote controller or "TIMER"of control panel, LED display will show "01". (Electrify for the first time) b) Set desired number by pressing the ( ) pad of he Temp/Time buttons. If you passed the desired time use the ( ) pad key to lower the selection. When using the timer the unit will use/revert to the last A/C , fan settings when activated . The timer must be reset every time you choose to use it . CLOSE OPEN Air filter (inside) Control panel Air inlet (outdoor side) Power plug Ventilation The ventilation lever must be CLOSE position in order to maintain the best cooling conditions. [. . . ] It is advisable to clean air filter every two weeks for longer operation. Take out the air filter 1. Press the concave parts on both sides at the lower part of air inlet grille to open the air inlet grille. CAUTION Before cleaning, turn off the power Do not raise the front panel any higher than 70° to the unit or damage to the tabs may occur. 3 Airflow Direction Airflow Direction Vane The Vertical Airflow Direction Vane is manually controlled by positioning the vane to discharge the air upward, downward or straight out. 2. Hold the hump of filter mesh with fingers (as illustrated) and take it out. Clean the filter 1. Gently flap the dirt off the air filter. [. . . ]