User manual HAIER HWPR06XC7

[. . . ] The fan can be set to run at 3 speeds as desired. c) DEHUMIDIFY This enables your air conditioner to operate as a dehumidifier as well. It will remove the excess moisture from the air to keep your room at a comfortable, dry stage. You can use this feature alone in case you do not wish to use the air conditioner. d) ENERGY SAVER When this feature is "On" , the fan will shut off three minutes after the compressor cycles off. [. . . ] All the display lights will turn on for 3 seconds. The LCD display will read"88", If any display light fails to turn on you may need service on the unit. After 3 seconds, the unit will automatically go to the stand by mode. Now all lights will be off and you will automatically to to the stand by mode. Now all lights will be off and you will have to turn"ON" by pressing the On/Off key. After pressing"On/Off", the unit starts to work and enters the status of "Fan" with the low setting. You will have to press the ( ) or ( ) key on the Temp/Time to set the temperature at your desired comfort. You can choose a temperature between 61 F and 86 F Once the temperature is set you can raise or lower it by pressing the . ( ) or ( ) keys. The temperature setting can only be adjusted when the unit is cooling. (See Fig. #2) Having set the temperature you will set the function of the air conditioner. REMOVE HEPA FILTER INSERT HEPA FILTER A MODE SPEED TIMER FAN ONLY HIGH MED LOW ON OFF MODE COOL ONLY ENERGY SAVER DEHUM SPEED AIR CLEANING TEMP / TIME LIGHT LOCK AIR CLEANING ONLY POWER Every time you press the MODE button, it will change between FAN, COOL, ENERGY SAVER and DEHUM. (See fig. #3) 8 C M Y CM MY CY CMY K REMOVE HEPA FILTER INSERT HEPA FILTER A MODE SPEED TIMER FAN ONLY COOL ONLY HIGH MED LOW ON OFF MODE ENERGY SAVER DEHUM SPEED AIR CLEANING TEMP / TIME LIGHT LOCK AIR CLEANING ONLY POWER Once the mode function is established, you will have to set the fan speed. #4) Every time you press the SPEED button, fan speed will change between LOW, MED, and HIGH. 1) If you choose the COOL mode you can run the fan in one of the 3 speeds: HIGH, MED, or LOW. 2) For cool days you may want to run the "FAN" function. Here the fan runs at one of 3 speeds (HIGH fan, MED fan, LOW fan) as desired by you. 3) The removes dehumidify function excess moisture from the air on excessively humid days. , 1) When Tr>Ts+3oF the compressor will run the fan continuously at the selected speed. , 2) When Ts-1¡ Tr¡ Ts+3oF the compressor will cycle for 10 minutes on and 6 minutes off. o , 3) When Tr<Ts-1 F the compressor will shut off. The dehumidification process takes place between the set temperature-1 and 3oF above the set temperature. 4) Energy Saver: The unit runs the same as the COOL setting in the ENERGY SAVER mode. But the fan will be off 3 minutes after the compressor cycle off. 9 C M Y CM MY CY CMY K REMOVE HEPA FILTER INSERT HEPA FILTER A MODE SPEED TIMER FAN ONLY COOL ONLY HIGH MED LOW ON OFF MODE ENERGY SAVER DEHUM SPEED AIR CLEANING TEMP / TIME LIGHT LOCK AIR CLEANING ONLY POWER Timer On or Timer Off mode is used to pre-start off your unit in advance. [. . . ] This can also increase the cooling efficiency of the air conditioner. Adjusting Horizontal Air Flow Direction Adjusting the vertical louvers left and right will change horizontal airflow. Adjusting Vertical Air Flow Direction Adjusting the Horizontal vane up and down will change vertical airflow. The vane can be adjusted by nudging the back or up and down of the vane. Adjusting Horizontal Air Flow Adjusting Vertical Air Flow Recommended orientation of louvers Adjust louvers to face upwards when cooling to maximize cooling efficiency . 12 C M Y CM MY CY CMY K HEPA Filter Replacement: We recommend that you had better replace the HEPA fil six months, please following the below steps to replace filter in the unit . 1. [. . . ]