User manual HAIER KD12W

[. . . ] If you cannot solve the problem, contact a service centre. - Only specialised personnel are authorised to make repairs. - Appliances which are being discarded must be made inoperable by cutting the power supply cord and removing the door lock. - The appliance must be positioned so that the plug is accessible. [. . . ] Pull out the rack to load the dishwasher. - Make sure that the plug for the appliance is inserted into the wall Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. Lower Rack Upper Rack socket. - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled, "Loading the Dishwasher" on page 5). - Pour in the detergent (see the section entitled, "Salt, Detergent and Rinse Aid" on page 3 and 4). - Turn the knob located on the right of the control panel in clockwise direction until the number or symbol for the cycle setting is aligned with the reference mark (see the section entitled, "Wash Cycle Table" on page 8). STOP How to use the lower rack We recommend that you place the most difficult to clean items on the bottom rack: pots, pans, lids, serving dishes and bowls, as shown in the figure to the right. It is preferable to place serving dishes and lids on the sides of the racks in order to avoid blocking the rotation of the top spray arm. - Deep pots should be slanted to allow the water to flow out. - The silverware basket can not be doubled (see fig. A). 1 Load for 12 Standard Settings - Press the ON-OFF button, and the ON-OFF light will turn on. At A cycle that is underway can only be modified if it has been this point, the wash cycle will begin. Otherwise, the detergent may have alIf you forget to load some of the dishes ready been used, and the appliance may have already drained The wash cycle can be interrupted by pressing the ON-OFF button. If this is the case, the detergent dispenser must You can then load additional dishes and turn the appliance back be refilled (see the paragraph entitled, "Loading the Detergent" 2 on. The cycle will start where it left off. Cancelling or modifying a wash cycle setting How to use the upper rack The upper rack is designed to hold more delicate and lighter dishware, such as glasses, cups and saucers, plates, small bowls and shallow pans (as long as they are not too dirty). - Position the dishes and cookware so that they do not get moved by the spray of water. The upper rack can be adjusted for height by using the knobs located on both sides of the rack itself (see fig. B). Adjust the upper basket to the higher level and you have more space to accommodate those taller pans and trays in the bottom basket. 3 At the end of the wash cycle When the knob stops turning and is aligned with a STOP mark 4 (see figure), the cycle has finished. Turn off the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher. on page 4). Press the ON-OFF button, and the ON light will turn off. Rotate the knob in clockwise direction to the desired cycle setting (see the section entitled: Starting a wash cycle ?F. [. . . ] After turning off the water tap, unscrew the end of the water supply hose, remove the filter and clean it carefully under running water. Then, return the filter to its place and tighten the water supply hose back into position. fig. 2 Troubleshooting The Dishes Are Not Clean It may occur that the dishwasher does not function properly or at all. Before calling for assistance, Iet us see what can be done first: Have you forgotten to press one of the buttons or to perform an essential operation?Have you checked whether: - the water is turned on and the hose is connected properly; - the water supply to the house is on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. Hot Water Connection The water supply to the appliance can also be connected to the house's hot water line (centralised system, heating system), as long as it does not exceed a temperature of 60°C. [. . . ]