User manual HAIER LSI45HLA000

[. . . ] - Dévissez le bouchon du distributeur de sel; - Le distributeur de sel est doté d'une bague sur laquelle figure une flèche (voir la figure ci-contre). NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. This appliance complies with the following EEC directives: -73/23/EEC of 19 February 1973 (Low Voltage) and subsequent modifications; - 89/336/EEC of 3 May 1989 (Electromagnetic Compatibility) and subsequent modifications. - Carefully dispose of the packing material. [. . . ] the "D" indicator light will come on. At this point, the appliance is on and ready to be programmed. If you forget to load some of the dishes. The wash cycle can be interrupted by opening the door carefully (in order to avoid being sprayed by hot water). When the door is closed again, the cycle will automatically restart at the point where it left off. Open the door, turn off the appliance using the ON/OFF switch and turn off the water supply to the unit. Wait a few minutes before removing the dishes so as to avoid handling them while still hot (when they are more susceptible to breakage) and to get better drying results. Each time it is pressed, one of the cycle indicator lights "A" will come on in succession. Choose the wash cycle you feel is most appropriate for the type of dishes that need washing (consult the wash cycle table contained in this manual, especially when first using the appliance). Close the door and press the "E" programming button, a short acoustic signal will sound indicating that the wash cycle has begun and cannot be modified. If necessary, read the paragraph entitled, "Cancelling or modifying a cycle while underway. "The end of the cycle will be signalled by a double acoustic sound, and the indicator light "A" will begin to blink. The start time for the wash cycle can be delayed for 2, 4 or 6 hours. Each time the button is pressed, the "H" light will come on indicating the length of the delay. After selecting the delay time, the wash cycle can be set, as explained in "Starting a wash cycle. " There will be a short acoustic signal, and at this point the delay period will begin to count down. During this period the delay indicator light (H) will blink. If the dishwasher is switched off through the ON/OFF button, or the power is cut suddenly while the selected washing program is active, the program is not cancelled. The controls use a microprocessor device, to memorize the information about the selected washing program. Once the machine is again powered on, the dishwasher will be resumed from the point it was interrupted. If the power to the appliance goes off or the door is opened during the delay period, the clock will stop the countdown. It will start again when the power has come back on, or when the door has been closed. [. . . ] The back should rest against the wall behind it, and the sides along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation. The water supply hose must not, under any circumstances, be cut, as it contains electrical parts which are live. If the length of the hose is not adequate to make a proper connection, the hose must be replaced with one which is long enough. [. . . ]