User manual HAMA 12306 4 EN 1

[. . . ] Use 2 „AAA“ (LR 03/Micro) type batteries. –º ► Remove the battery compartment lid on the back of your URC (A). –º ► Check the required battery polarity and insert batteries according to the “+/–” marks inside the compartment (B). ► ► Close battery compartment lid (C). [. . . ] The default setting for the scan time per single code is 1 sec. If this feels uncomfortable , you can switch to 3 sec. To switch between the scan times, press PROG+ or PROG- during the 6 sec. Latency before Auto Code Search starts scanning. 5 The LED indicator confirms each single code scan with a single flash. 6 Press MUTE(OK) to save the code and exit the code search. 7 To stop the Auto Code Search during the scan process, press the EXIT key. Note► ► Internal memory limitations allow only up to 350 most common device codes to be preloaded. Due to the extensive number of different available A/V devices on the market, it may be possible that only the most common main functions are available. No code may be available for some special device models. 3 Auto Code Search Auto Code Search uses the same preloaded codes as the Manual Code Search (5. 2) but your Universal Remote Control scanns through the codes automatically until the device you want to control shows a reaction. This might be that the device you want to control switches off (POWER key) or changes the channel (P+/P- keys). 1 Turn on the device you want to control 5. 2 Press the SETUP key until the LED indicator is permanently lit. 3 Select the device you want to control using the device key (e. A successful selection is indicated by the LED with one flash followed by permanent light. 4 Press the PROG+/PROG- keys or POWER to start the Auto Code Search. The LED indicator flashes once followed by permanent light. The Universal Remote Control has a latency of 6 seconds before the first scan starts. 4 Note► ► When all codes are searched without success, the Universal Remoote Control exits Auto Code Search and returns to operational mode automatically. 4 Code Identification The Code identification offers you the possibility, to determine an already entered code. [. . . ] Consumers are obliged by law to return electrical and electronic devices as well as batteries at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, reusing the materials or other forms of utilising old devices/Batteries, you are making an important contribution to protecting our environment. [. . . ]