User manual HAMA ROC2407 CODES

[. . . ] In this package you will find: · Mounting hardware for rain gauge (4 sets of screws & plastic screw plugs) · 18 cm) in diameter (to mount the anemometer) Installation The weather station operates at 433MHz and does not require wire installation among the component parts. To ensure successful installation and the best performance, we recommend you follow the installation instructions in the order they appear in this manual. Battery & adapter installation for the monitor (receiver) Main power source: Open the battery door and insert 6 pieces of AA batteries according to the polarity indicated, close the battery cover. 0V adapter jack into the side of the unit for basic operation (Adapter not included) Sea level pressure setting After battery/adapter installation, the monitor will enter sea level pressure setting mode directly and the pressure reading will flash. [. . . ] Remove the cover and insert 2 AA alkaline batteries as indicated by the polarity symbols marked inside the battery compartment. The rain cup has been sealed to prevent tipping and damage during shipping. Before first use please remove the seal to allow the rain cup to fill and empty when rainfall occurs. Total rainfall reading (in this case "0" mm or inch) will appear within 2 minutes if the RF transmission is successful and the monitor & rain gauge are now within the effective transmission range. If total rainfall "- - - - " stop flashing and stay on the display after 2 minutes of searching, the RF transmission is failed. Shorten the distance between the monitor & rain gauge. Reset the rain gauge by removing all batteries from the rain gauge and wait for 10 seconds before re-installing the batteries again. Then repeat step 5 (& 6) until the RF communication is completed. Mounting the rain gauge Before mounting the rain gauge, be sure the rain gauge & monitor are within the transmission effective range and batteries are installed. Hold the base of the rain gauge flat against the mounting surface then use a level to make sure the rain gauge (as it rest on the mounting surface) is horizontally level. Use a pencil to trace the inside of the mounting holes on the base of the rain gauge to mark the screw locations. Ice Alert Ice alert indicator appears on the display next to the wind chill reading when outdoor channel-1 temperature falls to or below 4C (or 39. It provides an early alert for possible icy road condition to driver. IN/OUT heat index Heat Index combines the effects of heat and humidity. It is the apparent temperature of how hot the heat-humidity combination makes it feels. Press "Heat Index/Dew Point" button once to show the respective indoor or outdoor heat index on the display. "HEAT INDEX" icon will appear. IN/OUT dew point Dew point is the saturation point of the air, or the temperature to which the air has to be cooled in order to get condensation. Press HEAT INDEX / DEW POINT button twice to show the respective indoor or outdoor dew point reading on the display. Press "RAIN/CLEAR" repeatedly to switch between the different modes and the corresponding "DAILY", "WEEKLY", "MONTHLY" or "TOTAL" icon will appear In daily, weekly or monthly rainfall display, hold "RAIN/ CLEAR" to clear all daily, weekly & monthly rainfall reading to zero. in total rainfall display , hold "RAIN/ CLEAR" to clear total rainfall reading. Press "RAIN UNIT" on the back casing to change the unit between mm and inch. [. . . ] The related low alarm icon will continue to flash until the alarm condition is no longer met. Maximum & minimum records Press "MEMORY" repeatedly to view the maximum & minimum values of temperature, humidity, heat index, dew point, wind speed & wind chill readings. the corresponding "MAX" and "MIN" icons will appear. To clear the memory record, hold "MEMORY" in the max/min display mode Radio-controlled clock The unit will start synchronizing the radio-controlled clock after battery/adapter installation. [. . . ]