User manual HAMILTON M-400

[. . . ] 400 D / 800 D M-300 / M-400 Installation Instructions for Furnace Humidifier Plastic Models - Standard and Self-cleaning Please read the instructions carefully before starting the installation. Version 3 - June 2001 For future use, please copy the free help line number into the space below. Free help line for technical assistance: 1-800-879-0123 BEFORE YOU START - GENERAL SAFETY AND INSTALLATION PRECAUTIONS Please read and understand these instructions fully before you begin this installation and save them for future reference. The manufacturer will assume no responsibility and the warranty will be void if the user does not adhere to the following precautions. WARNINGS AND DISCLAIMER Installation Precautions 1) This humidifier will be connected to and used under water pressure and it must be installed in such a way that if a leak occurs, the water could not cause any damage to the property. Make sure all water connections are properly installed or water spill could occur. 2) This humidifier is intended for use on forced warm air circulation furnaces, as well as multi-fuel furnaces where temperature does not exceed 180°F (82ºC). [. . . ] If the knockout hole is not big enough to receive the drain mechanism, enlarge it a little bit with a small cutter. Install the drain box in the water pan, the two screws of the cover towards the back of the pan. The box (15. 2) has to sit between the ribs (15. 6) in the water pan. The paddle wheel (15. 7) is on the right side. Make sure the rubber "O" ring (15. 3) is between the drain box housing (15. 2) and the bottom of the water pan (15. 1). Secure the drain box (15. 2) to the water pan (15. 1) with the plastic nut (15. 4), without stripping. If the motor is on the left side of the humidifier, the draining system must be reversed. Please do the following: After having opened the left knockout hole, install the draining system in hole of the water pan as described above. The paddle wheel (17. 5) is still on the right side. Remove the two screws (16. 3) retaining the cover (16. 4) and open the draining mechanism. Carefully lift the inside plunger (16. 1) and the spring (16. 2) and remove them from the box. Please note that the two ribs (17. 3) on the shaft (17. 2) are sitting on the right wall of the box (17. 1). Take the shaft and flip it so the paddle wheel (17. 5) is on the left side, the two ribs (17. 3) on the shaft sitting now on the left wall of the box (17. 4). Put the plunger (16. 1) back in its original position, then reinstall the spring (16. 2) in the middle of the plunger. Hook the plastic cover (16. 4) in the front wall of the box, making sure that the spring (16. 2) sits around a plastic protrusion (16. 5) in the center of the cover (16. 4). Carefully put the two screws (16. 3) back in place to hold the cover, without stripping. CAUTION: Please make sure that the piercing needle is completely recessed into the valve body by turning the handle counter clockwise. · · · · · · Assemble one side of top clamp (13. 1) to bottom clamp (13. 2) with a screw (13. 3) and a nut (13. 4). Make sure that the rubber gasket (13. 5) is in place over the piercing needle and position the valve assembly on the copper water line. Assemble the other side of the top clamp (13. 1) to the bottom clamp (13. 2) with the remaining screw and nut. Tighten the two screws so that the valve is firmly attached to the water pipe. The two sides of the clamp must be parallel. [. . . ] Please use measurements given to obtain actual size. J MODEL 400D/800D Humidifier Limited One-Year Product Warranty Lifetime Frame and Cover Guarantee This limited one-year warranty and lifetime frame and cover warranty cover this Hamilton Humidifier as designated on the return portion of the warranty registration card, excluding wiring, plumbing, and installation. warrants that all new Hamilton Humidifiers are free from defects in material and workmanship under normal, non- commercial use and service. Hamilton will remedy any such defects as they appear within 12 months from the date of original installation as evidenced by receipt of the warranty registration card, subject to the terms and conditions of this limited oneyear warranty stated below: 1) This limited one-year warranty is granted by Hamilton Home Products, Inc. PO Box 12039, Columbus, Ohio 43212 2) This warranty shall extend only to any non-commercial owner who has purchased this residential product other than purpose of resale. [. . . ]